A geometrical optics model based on the non-Gaussian probability density distribution of sea surface slopes for wind speed retrieval at low incidence angles

Xiuzhong Li,Yijun He,Biao Zhang,Junxiang Ge,Xiaoqing Chu
DOI: https://doi.org/10.1080/01431161.2015.1131870
IF: 3.531
2016-01-21
International Journal of Remote Sensing
Abstract:In this study, a large amount of data from precipitation radar (PR) and National Data Buoy Center (NDBC) buoys are collocated for the development and validation of a Geometrical Optics Model, in order to retrieve wind speed at small incidence angles. The omni-directional model is developed based on the combination of the quasi-specular scattering theory and non-Gaussian probability density distribution of ocean surface slope, and can be applied at incidence angles as high as 15°. There are four parameters included in the proposed model: the effective Fresnel reflection coefficient, the mean square slope, and the two coefficients associated with the kurtosis of the sea surface slope distribution. Using one half of the collocated data, the dependence of the four parameters on the in situ wind speed is acquired. The results show that the effective Fresnel reflection coefficient has a decrease relative to that obtained in previous studies. We combine the proposed model with the maximum-likelihood estimation (MLE) technique to retrieve the ocean surface wind speed at the 10 m height. The retrieved wind speeds are then validated against those measured by the NDBC buoys. The comparison shows that the root mean square error (RMSE) and bias between the model retrievals and buoy observations are 1.54 m s–1 and 0.1 m s–1, respectively, revealing high agreements in the wind speed estimations. The results of this study indicate that the proposed model and the PR measurements at low incidence angles can provide reasonably accurate estimates of the surface wind speeds within the range of 0–20 m s–1.
imaging science & photographic technology,remote sensing
What problem does this paper attempt to address?