Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Monitoring of bone healing by piezoelectric-EMI method

Piezoelectric Sensing Techniques in Structural Health Monitoring: A State-of-the-Art Review

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Piezoelectric-Based Smart Bone Plate for Fracture Healing Progress Monitoring

Piezoelectric sensor based nondestructive active monitoring of strength gain in concrete

Sub-Frequency Interval Approach in Electromechanical Impedance Technique for Concrete Structure Health Monitoring

Shape memory alloy actuation of non-bonded piezo sensor configuration for bone diagnosis and impedance based analysis

A Review of the Piezoelectric Electromechanical Impedance Based Structural Health Monitoring Technique for Engineering Structures

Research on Piezoelectric Impedance Technology for Structural Health Monitoring

Wireless Measurements Using Electrical Impedance Spectroscopy to Monitor Fracture Healing

Piezoelectric Impedance Sensor-Based Structural Health Monitoring for Critical Members of Civil Infrastructures

Sensor Fault Diagnosis for Impedance Monitoring Using a Piezoelectric-Based Smart Interface Technique

Multiple damage detection in piezoelectric ceramic sensor using point contact excitation and detection method

Development And Application Of Structural Health Monitoring System Based On Piezoelectric Sensors

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

Piezoelectric Materials and Sensors for Structural Health Monitoring: Fundamental Aspects, Current Status, and Future Perspectives

Health monitoring of steel structures using surface mountable and detachable PZT sensor

A Passive and Wireless Sensor for Bone Plate Strain Monitoring

Damage detection for structural health monitoring using ultra-sensitive flexible piezoelectret sensors

Adhesive curing effect of bonded piezoelectric transducer on electromechanical impedance-based concrete structural damage detection

Wireless Structural Health Monitoring for Critical Members of Civil Infrastructures Using Piezoelectric Active Sensors