Abstract:Due to the stratified construction of additive manufacturing (AM), the building orientation of an object greatly affects the manufacturing process and quality of the products. This article proposes an optimization algorithm for AM that comprehensively covers the three main aspects affected by the building direction: efficiency, surface quality, and internal properties. The goal of optimizing efficiency is to cut the manufacturing and postprocessing times by reducing the support volume. In terms of surface quality optimization, a new and comprehensive mathematical model is established. Considering not only the influence of the stepping effect on the whole model but also the supporting contact area, the optimization to the salient area was innovatively proposed. The salient area was defined by cone curvature, which has a significant influence on appearance. Another novel point is the quantitative optimization of the internal properties, which is based on the anisotropic characteristics of AM. The mechanical properties are taken into consideration in this article, and other anisotropic properties can be added to the optimization algorithm by using the same method. Afterward, a particle swarm optimization algorithm was adopted to synchronously optimize the targets just cited, according to the degree of importance of each factor for specific applications. The algorithm was implemented to optimize several different cases with different characteristics. Further, the results in the experiments manifested that the models printed in the optimized orientation performed better than the initial models, and the corresponding comprehensive evaluation scores were improved as well, with an optimization range of 70-90%. And the rate of optimization for support volume, surface roughness, salient area roughness, and maximum tensile strength, respectively, reached 20.9%, 57.3%, 59.5%, and 293.0%.

Bézier-based biased random-key genetic algorithm to address printability constraints in the topology optimization of concrete structures

Self-supporting Topology Optimization for Additive Manufacturing

Isogeometric Analysis-Based Design of Post-Tensioned Concrete Beam Towards Construction-Oriented Topology Optimization

Bio-based Connections and Hybrid Planar Truss: A Parallel Genetic Algorithm Approach for Model Updating

Topology Optimisation of Self-Supporting Structures Based on the Multi-Directional Additive Manufacturing Technique

Constructing Self-Supporting Structures in Biscale Topology Optimization

An integrated topology optimization method including manufacturing constraints for 3D printed fiber-reinforced concrete structures

An integrated method of topological optimization and path design for 3D concrete printing

A post-topology optimization process for overhang elimination in additive manufacturing: design workflow and experimental investigation

Topology Optimization of Dynamic Response : Methods , Materials and Additive Manufacturing ( Sim-AM 2019 )

Topology optimization for additive manufacturing with length scale, overhang, and building orientation constraints

Structural aspects of topology optimization in 3D printing of concrete

Internal topology optimisation of 3D printed concrete structures: a method for enhanced performance and material efficiency

Building Orientation Determination Based On Multi-Objective Optimization For Additive Manufacturing

Additive manufacturing-driven design optimization: Building direction and structural topology

Direction-Oriented Stress-Constrained Topology Optimization of Orthotropic Materials

A multiobjective topology optimization approach for cost and time minimization in additive manufacturing

Printing Ready Topology Optimization for Material Extrusion Polymer Additive Manufacturing

Strength-constrained simultaneous optimization of topology and fiber orientation of fiber-reinforced composite structures for additive manufacturing

Topology design of 3D printing continuous fiber reinforced structure considering strength and non‐equidistant fiber

Topology optimization with nozzle size restrictions for material extrusion-type additive manufacturing