Abstract:Ejector refrigeration systems pose a promising alternative to vapour compressor technologies. Still, they have not been penetrating the market because of the strong dependency of the ejector behaviour ("component-scale") on the underlying fluid-dynamics ("local-scale"), which directly affects the system performances ("system-scale"). Furthermore, within the broader discussion concerning refrigerant phase-out, the refrigerant selection is a cutting-edge and challenging task, especially because the ejector performance is influenced by the coupling taking place between the working fluid and component design. This paper contributes to the broader framework of ejector research investigating the complex relationships between the factors mentioned above that arise during the operation of a standard ejector refrigeration system. An integrated model (CFD-LPM) has been applied to compare fourth generation and natural refrigerants (R1233zd(E), R1234yf, R1234ze(E), R290, R1270, and R600a) to commonly used refrigerants (R134a, R245fa, R152a) on five ejector geometries, obtained changing the nozzle exit position and the mixing chamber throat dimension from a reference case. Based on the results in terms of performance curves, tested refrigerants could be divided into three groups: (i) R1270 and R290, having higher COP (0.5 – 1.03) but lower critical temperature Tcrit (20.7 – 25.0 °C), (ii) R134a, R152a, R1234yf, R1234ze R600a, with an intermediate value of COP (0.27 – 0.83) and critical temperature Tcrit (22.8 – 28.0 °C), (iii) R245fa and R1233zd, with lower COP (0.25 – 0.58) but higher critical temperature Tcrit (26.0 – 31.0 °C). Increasing nozzle exit position has been found to slightly affect the performances (+5% COP) while the ejector entrainment process has been found to highly depend on the mixing chamber diameter (up to +35% COP). One of the tested geometries has been then selected, with R290 as operative fluid, to perform a boundary conditions sensitivity analysis. This led to the definition of a system performance map for different system temperature levels at the generator and evaporator.

An applicable surface heating in a two-phase ejector refrigeration

Investigation on A Two-Stage Ejection Refrigeration System

Experimental investigation on two-phase driven ejector performance in a novel ejector enhanced refrigeration system

Experimental Investigations on A R134a Ejector Applied in A Refrigeration System

Ejector Performance of a Pump-Less Ejector Refrigeration System Driven by Solar Thermal Energy.

An Investigation on the Component Efficiencies of a Small Two-Phase Ejector

Theoretical Study on A Novel R32 Refrigeration Cycle with A Two-Stage Suction Ejector

Ejector Used in Transcritical CO_2 Heat Pump System

Performance Study of an Enhanced Ejector Refrigeration Cycle with Flash Tank Economizer for Low-Grade Heat Utilization

Energy and Exergy Efficiency Analysis of Solar Driven Ejector–compressor Heat Pump Cycle

Improvement of the wet steam ejector performance in a refrigeration cycle via changing the ejector geometry by a novel EEC (Entropy generation, Entrainment ratio, and Coefficient of performance) method

Energy and Exergy Analysis of a Novel Two-Stage Ejector Refrigeration Cycle Using Binary Zeotropic Mixtures{fr}analyse De L’énergie Et De L'exergie D'un Nouveau Cycle De Réfrigération À Éjecteur À Deux Étages Utilisant Des Mélanges Zéotropes Binaires

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Application of machine learning to enhance the performance of a two-stage, two-temperature ejector cycle driven by the waste heat of exhaust gas

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

A full operating conditions ejector model for refrigeration systems driven by low-grade heat sources

The performance analysis of a variable geometry ejector utilizing CFD and artificial neural network

Analysis of Refrigeration Cycle Performance with an Ejector

Step Utilization of Energy with Ejector in a Heat Driven Freeze Drying System

Numerical investigation in effects of refrigerants' thermodynamic properties on performance of supersonic ejector

Multi-scale evaluation of ejector performances: The influence of refrigerants and ejector design