Methane adsorption in nanoporous carbon: the numerical estimation of optimal storage conditions

L Ortiz,B Kuchta,L Firlej,M W Roth,C Wexler
DOI: https://doi.org/10.1088/2053-1591/3/5/055011
IF: 2.025
2016-05-09
Materials Research Express
Abstract:The efficient storage and transportation of natural gas is one of the most important enabling technologies for use in energy applications. Adsorption in porous systems, which will allow the transportation of high-density fuel under low pressure, is one of the possible solutions. We present and discuss extensive grand canonical Monte Carlo (GCMC) simulation results of the adsorption of methane into slit-shaped graphitic pores of various widths (between 7 Å and 50 Å), and at pressures P between 0 bar and 360 bar. Our results shed light on the dependence of film structure on pore width and pressure. For large widths, we observe multi-layer adsorption at supercritical conditions, with excess amounts even at large distances from the pore walls originating from the attractive interaction exerted by a very high-density film in the first layer. We are also able to successfully model the experimental adsorption isotherms of heterogeneous activated carbon samples by means of an ensemble average of the pore widths, based exclusively on the pore-size distributions (PSD) calculated from subcritical nitrogen adsorption isotherms. Finally, we propose a new formula, based on the PSD ensemble averages, to calculate the isosteric heat of adsorption of heterogeneous systems from single-pore-width calculations. The methods proposed here will contribute to the rational design and optimization of future adsorption-based storage tanks.
materials science, multidisciplinary
What problem does this paper attempt to address?
This paper aims to solve the problem of adsorption and storage of natural gas (especially methane) in nanoporous carbon materials. Specifically, the research objectives include: 1. **Understand the density distribution of the adsorption film**: Through atomic - level research, understand the influence of different pore sizes on the structure of the methane adsorption film, especially the occurrence conditions and mechanisms of the multi - layer adsorption phenomenon. 2. **Optimize storage conditions**: By simulating the methane adsorption under different pore sizes (from 7 Å to 50 Å) and pressures (from 0 bar to 360 bar), explore the optimal storage conditions to achieve efficient methane storage at low pressure. 3. **Model heterogeneous porous materials**: Using the ensemble average of the idealized monodisperse model, successfully simulate the experimental adsorption isotherms of heterogeneous activated carbon samples, including the excess adsorption isotherm, the storage isotherm and the adsorption enthalpy. 4. **Propose a new calculation method**: Based on the ensemble average of the pore size distribution (PSD), propose a new formula to calculate the isothermal adsorption heat in heterogeneous systems, which is helpful for the design and optimization of future adsorption - based storage tanks. Through these studies, the paper provides an important theoretical basis and technical support for the development of cost - effective and high - performance adsorbents, especially nanoporous carbon materials for natural gas storage.