Abstract:The methodology and test results of a three-phase three-column transformer with a Dy connection group are presented in this paper. This study covers the dynamics of events that took place in the first period of the transient state caused by the energizing of the transformer under no-load conditions. The origin of inrush currents was analyzed. The influence of factors accompanying the switch-on and the impact of the model parameters on the distribution and maximum values of these currents was studied. In particular, the computational methods of taking into account the influence of residual magnetism in different columns of the transformer core, as well as the impact of the time instant determined in the voltage waveform at which the indicated voltage is supplied to a given transformer winding, were examined. The study was carried out using a nonlinear model constructed on the basis of classical modeling, in which hysteresis is not taken into account. Such a formulated model requires simplification, which is discussed in this paper. The model is described using a system of stiff nonlinear ordinary differential equations. In order to solve the stiff differential state equations set for the transient states of a three-phase transformer in a no-load condition, a Runge–Kutta method, namely the Radau IIA method, with ninth-order quadrature formulas was applied. All calculations were carried out using the authors' own software, written in C#. A ready-made strategy for energizing a three-column three-phase transformer with a suitable pre-magnetization of its columns is given.

A Method Based on Linear Prediction for Inrush Current Detection

A New Method to Identify Inrush Current Based on Error Estimation

A New Method to Identify Inrush Current Based on HHT

A NEW METHOD TO IDENTIFY INRUSH CURRENT BY PHASOR COMPARISON

An innovative harmonic‐based approach for inrush current detection in low‐loss transformers

A Design of Inrush Current Identification System for High-Speed Train's Traction Transformer

Deep Learning-Based Algorithm for Internal Fault Detection of Power Transformers during Inrush Current at Distribution Substations

Unified Algorithm Based on Rotating Phasors for Accurate Detection of Inrush Currents in Three-Phase Transformers

Identification of Inrush Current Using a GSA-BP Network

IDENTIFICATION OF TRANSFORMER MAGNETIC INRUSH CURRENT BASED ON VIRTUAL FLUX AND DIFFERENTIAL CURRENT CHARACTERISTICS

Solid-State Inrush Current Limiter Controller Based on Inrush Prediction for Large Transformers

A new algorithm to identify magnetizing inrush of converter transformers in HVDC transmission project

Identifying Inrush Current for Large-Scale Wind Parks Transformers Based on Difference Function of Differential Current

Approach to Calculate Attenuated Magnetizing Inrush Current in Transformer

Inrush Current Reduction Strategy for a Three-Phase Dy Transformer Based on Pre-Magnetization of the Columns and Controlled Switching

Mitigating the Inrush Current of V/V Transformers Using Railway Conditioners

Equivalent Instantaneous Inductance Based Inrush Current Identification for Three-Phase V/V Traction Transformer

Transformer Differential Protection Method for Recognition between Power Transformer Internal Defects and Inrush Current: A Comprehensive Review of Detection Techniques

FPGA-Based Smart Sensor to Detect Current Transformer Saturation during Inrush Current Measurement

Correlation Analysis of Waveforms in Non-Saturation Zone Based Method to Identify the Magnetizing Inrush in Transformer

Preventing maloperation scheme for saturation protection of converter transformers based on waveform prediction of magnetizing inrush current