Abstract:The aerodynamic drag characteristics of a passenger car have, typically, been defined by a single parameter: the drag coefficient at a yaw angle of 0°. Although this has been acceptable in the past, it does not provide an accurate measure of the effect of aerodynamic drag on fuel consumption because the important influence of the wind has been excluded. The result of using drag coefficients at a yaw angle of 0° produces an underprediction of the aerodynamic component of fuel consumption that does not reflect the on-road conditions. An alternative measure of the aerodynamic drag should take into account the effect of non-zero yaw angles, and a variant of wind-averaged drag is suggested as the best option. A wind-averaged drag coefficient is usually derived for a particular vehicle speed using a representative wind speed distribution. In the particular case where the road speed distribution is specified, such as for a driving cycle to determine fuel economy, a relevant drag coefficient can be derived by using a weighted road speed. An effective drag coefficient is determined with this approach for a range of cars using the proposed test cycle for the Worldwide Harmonised Light Vehicle Test Procedure, WLTP. The wind input acting on the car has been updated for this paper using recent meteorological data and an understanding of the effect of a shear flow on the drag loading obtained from a computational fluid dynamics study. In order to determine the different mean wind velocities acting on the car, a terrain-related wind profile has also been applied to the various phases of the driving cycle. An overall drag coefficient is derived from the work done over the full cycle. This cycle-averaged drag coefficient is shown to be significantly higher than the nominal drag coefficient at a yaw angle of 0°.

Aerodynamical characteristics of a reduced scale ground vehicle according to yaw angle variations

Drag Force on a Free Surface-Piercing Yawed Circular Cylinder in Steady Flow

A Measurement Technique On The Hydrodynamic Force On The Free Surface-Piercing Cylinder At A Yawed Angle

Experimental and numerical investigation of the aerodynamic characteristics of high-performance vehicle configurations under yaw conditions

Aerodynamic drag reduction of a simplified squareback vehicle using steady blowing

Modal Analysis and Flow Control on a Reduced Scale SUV

Wake Structures and Surface Patterns of the DrivAer Notchback Car Model under Side Wind Conditions

A drag coefficient for application to the WLTP driving cycle

Aerodynamics of the square-back Ahmed body under rainfall conditions

Toward the Usage of Deep Learning Surrogate Models in Ground Vehicle Aerodynamics

Evaluation of wind tunnel interference on numerical prediction of wheel aerodynamics

Experimental and numerical investigation on the influence of different detailed and deformed tires on the aerodynamics of electric vehicles

Introduction of a New Car Model Series for Aerodynamics Research

Optimization of aerodynamic drag reduction for vehicles with non-smooth surfaces and research on aerodynamic characteristics under crosswind

Extended Study of Full-Scale Wind Tunnel Test and Simulation Analysis Based on DrivAer Model

Identification of Engine Thrust and Aerodynamic Drag Force According to Flight Test Data with Smoothing of Random Measurement Errors

Estimation of Vehicle's Vertical and Lateral Tire Forces Considering Road Angle and Road Irregularity

A Method for Truck Underbody Aerodynamic Investigation

CFD Analysis on Effect of Front Windshield Angle on Aerodynamic Drag

On the aerodynamic effects of the optimised DrivAer fastback model car under adverse situations

Influence of wind speed and road grade on the estimation of drag area in cycling