Abstract:Lean-burn natural-gas spark-ignition combustion inside a diesel geometry is characterized by two distinct and successive events: a rapid burning process inside the piston bowl, followed by a much slower burn inside the squish region. This paper used experimental data (including images of flame natural luminosity) to investigate the magnitude and phasing of these two combustion stages. The results showed a substantial impact on the parameters generally used to investigate the combustion phenomena in spark-ignition engines (e.g., the 10-to-90-percent energy release). A better solution to identify the start and end of the rapid- and the slow-burning stages in such an engine is to use the inflection points in the apparent rate of heat release. Moreover, as the higher turbulence in a diesel-like environment accelerates flame inception, the 5% or 10% energy release used traditionally to define the flame inception period should not be used for these engines because the enflamed zone already reached an appreciable size at the two corresponding crank angle degrees. Further, the 2nd inflection point in the apparent rate of heat release (i.e., the point where the slow-burning stage started to dominate the heat release) was much advanced compared to 90% energy release generally used to define the end of the rapid-burning stage in conventional stoichiometric spark-ignition engines. Furthermore, as the slow-burning stage was characterized by a lower flame propagation speed, a lower fuel fraction burning during this stage would increase the engine combustion efficiency. Furthermore, a more advanced phasing of the late-burning stage relative to the fast-burn stage would result in a more optimal combustion environment (i.e., higher in-cylinder pressure and temperature), which would further improve the engine efficiency and probably reduce carbon monoxide and unburned hydrocarbon emissions. As a result, this study suggests that the combustion strategy of such converted diesel engines should advance and optimize the mass of fuel that burns inside the squish region.

Fundamental Study on Combustion Improvement by Mixture-Flow in Natural Gas-Fueled Lean-Burn SI Engines

Methodology to Separate the Two Burn Stages of Natural-Gas Lean Premixed-Combustion Inside a Diesel Geometry

Optical and Numerical Investigations of Flame Propagation in a Heavy Duty Spark Ignited Natural Gas Engine

Analysis of Two-Stage Natural-Gas Lean Combustion Inside a Diesel Geometry

Observation of Flame Propagation in a Heavy-Duty Natural-Gas Lean Burn Spark-Ignition Engine

An Experimental Investigation of Early Flame Development in an Optical Spark Ignition Engine Fueled with Natural Gas

Two-Stage Lean-Burn Combustion Inside a Natural-Gas Spark-Ignition Engine with a Bowl-in-Piston Chamber

Experimental Setup of Combustion Visualization Inside a Heavy-Duty Diesel Engine Converted to Natural-Gas Spark-Ignition Operation

Flame Development Analysis in a Diesel Optical Engine Converted to Spark Ignition Natural Gas Operation

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Investigation of Multistage Combustion Inside a Heavy-Duty Natural-Gas Spark-Ignition Engine Using Three-Dimensional Computational Fluid Dynamics Simulations and the Wiebe-Function Combustion Model

Twin-Peak Heat Release Phenomenon Inside a Heavy-Duty Diesel Engine Retrofitted to Natural-Gas Spark Ignition

Combustion of Premixed Ammonia and Air Initiated by Spark- Ignited Micro-gasoline-jet in a Constant Volume Combustible Vessel

Experimental Investigation of Low-Temperature Autoignition in Turbulent Premixed Swirling Flames

Study on the effect of high-pressure methane jet on lean burn laminar flame

The Relationship between In-Cylinder Flow-Field near Spark Plug Areas, the Spark Behavior, and the Combustion Performance inside an Optical S.I. Engine

Combustion partitioning inside a natural gas spark ignition engine with a bowl-in-piston geometry

Ultralean Combustion Mechanism of Methane–Air Swirling Premixed Flame

A Study on Combustion Characteristics of a High Compression Ratio SI Engine with High Pressure Gasoline Injection

Experimental Research of High-Pressure Methane Pulse Jet and Premixed Ignition Combustion Performance of a Direct Injection Injector

Combustion characteristics of ignition processes for lean premixed swirling combustor under visual conditions