Optical and numerical study on the effect of wall impingement on passive jet ignition characteristics of methane/air mixture
Yixiao Zhang,Xiao Ma,Jianshu Mao,Yuwen Fang,Changzhao Jiang,Zhi Wang,Shijin Shuai
DOI: https://doi.org/10.1016/j.fuel.2024.131467
IF: 7.4
2024-03-19
Fuel
Abstract:Pre-chamber turbulent jet ignition is a promising high-efficiency combustion technique to achieve stable lean-burn operation for spark-ignition engines. Wall impingement by a high momentum turbulent jet could exert a critical influence on jet ignition behavior. In this work, the passive jet ignition characteristics of premixed methane/air mixture under wall impinging condition was investigated based on optical experiments in a constant volume chamber and numerical simulations. Two ignition modes were found for flat wall impinging cases across a range of non-dimensional impinging distances ( H / D ) from 5.7 to 20. In mode 1, ignition initiates from near wall region. Under lean conditions of λ = 1.3, compared with that in the free jet case, the ignition delay time characterized by a 5 % mass fraction burned (MFB-05), decreases by 3.3 ms at H = 30 mm and increases by up to 6.6 ms at H = 20 mm. In mode 2, ignition initiates from the jet root. The ignition delay times are shorter for all impinging distances ( H = 20, 30, 40 mm), with MFB-05 decreasing by up to 3.4 ms. Simulations reveal that when the wall is located in the jet developing zone with H / D below 7, wall impinging deteriorates the ignition, which is attributed by higher turbulent kinetic energy (TKE) and lower Damköhler ( Da ) number near the stagnation zone, resulting in extended ignition delay. Conversely, as H / D increases, ignition is promoted by the stagnation effect with a shorter ignition delay. Additionally, the effect of wall shapes was analyzed. Using sharp-tip V-shaped wall, the stagnation region with high TKE is minimized. A blunt-tip V-shaped wall shows enhanced impinging but no obvious increase of Da number at stagnation point. Using M-shaped wall, the ignition mode with a "lift-off" flame was found. Besides, ignition is more favorable in the secondary jet zone with active radicals and higher Da number.
energy & fuels,engineering, chemical