Abstract:Ejector mode is a unique and critical phase of wide-range rocket-based combined cycle (RBCC) engine. In this paper, a quasi-one-dimensional thermodynamic performance modeling method, with more detailed model treatments for the inlet-diffuser system, primary/secondary flow interaction, and pressure feedback matching, was developed for operating characteristics studies and multi-objective optimization analysis of the ejector mode of an actual RBCC engine. A series of three-dimensional simulations of separate inlet and full flowpath was completed to validate the modeling study and provide further insight into the operating characteristics. The primary/secondary equilibrium pressure ratio functions a significant effect on ejector mode performance, a higher performance augmentation can be obtained by lower rocket pressure ratio, larger mixing section area ratio, smaller throttling throat and higher equivalence ratio, within an appropriate range. The positive performance augmentation can be realized at low flight Mach conditions, the coordination and trade-off relationships between specific impulse, performance augmentation ratio and thrust-to-area ratio during ejector mode are present by the Pareto-front from MOP analysis. It is further verified by CFD simulation that, the operating back-pressure at the exit of inlet-diffuser system functions a decisive influence on the airbreathing characteristics, the pressure feedback and matching should be well-controlled for secondary flowrate and performance augmentation. The thermodynamic modeling analysis results are basically consistent with those of numerical simulation, to validate the rationality and effectiveness of the modeling method.

Thermodynamic Modelling of an Ejector with Compressible Flow by a One-Dimensional Approach

An Investigation on the Component Efficiencies of a Small Two-Phase Ejector

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

An Improved 1-D Thermodynamic Modeling of Small Two-Phase Ejector for Performance Prediction and Design

A 1D Model to Predict Ejector Performance at Critical and Sub-Critical Operational Regimesmodèle Unidimensionnel Utilisé Pour Prévoir La Performance D'un Éjecteur Sous Des Conditions De Fonctionnement Critiques Et Sous-Critiques

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

A 1D Model for the Unsteady Gas Dynamics of Ejectors

Progress of mathematical modeling on ejectors

An extended mechanism model of gaseous ejectors

Thermodynamic performance modeling, optimization and numerical simulation of RBCC ejector mode

A 1D model to predict ejector performance at critical and sub-critical operational regimes

Novel Ejector Model for Performance Evaluation on Both Dry and Wet Vapors Ejectors

An Investigation on the Irreversibility in the CO2 Two-Phase Ejector Based on the One-Dimensional Distribution Model

Research on Co2 Ejector Component Efficiencies by Experiment Measurement and Distributed-Parameter Modeling

Progress in theoretical research on ejector

Novel Ejector Model with Experimental Validation

1D Model to Predict Ejector Performance at Critical and Subcritical Operation in the Refrigeration System

A Parametric Study on the Effect of Mixing Chamber for Expansion Work Recovery CO2 Ejector

Simplified Ejector Model for Control and Optimization

Model Investigation of Jet Flow Inside Two-phase Ejector

Study of Vapor Ejector Performance on Ejector Throat Diameter