Abstract:A rapid and sensitive immunoassay based on a sequential injection analysis (SIA) using magnetic microbeads for the determination of alkylphenol polyethoxylates (APnEOs) is described. An SIA system was constructed from a syringe pump, a switching valve, a flow-through type immunoreaction cell equipped with a photon counting unit and a neodymium magnet. Magnetic beads, to which an anti-APnEOs monoclonal antibody was immobilized, were used as a solid support in an immunoassay. The introduction, trapping and release of the magnetic beads in and from the immunoreaction cell were controlled by means of a neodymium magnet and adjusting the flow of a carrier solution. The immunoassay was based on an indirect competitive immunoreaction of an anti-APnEOs monoclonal antibody immobilized on the magnetic beads with a sample APnEOs and a horseradish peroxidase (HRP)-labeled APnEOs in the same sample solution, and was based on the subsequent chemiluminscence reaction of HRP on the magnetic microbeads with a luminol solution containing hydrogen peroxide and p-iodophenol. The anti-APnEOs antibody was immobilized on the magnetic microbeads by coupling the antibody with the magnetic beads after activation of a carboxylate moiety on the surface of the magnetic beads that had been coated with a polylactic acid film. The antibody immobilized magnetic beads were introduced in the immunoreaction cell and trapped in it by the neodymium magnet, which was equipped beneath the immunoreaction cell. An APnEOs sample solution containing the HRP-labeled APnEOs at a constant concentration, and a luminol solution containing hydrogen peroxide and p-iodophenol were sequentially introduced into the immunoreaction cell, according to an SIA programmed sequence. Chemiluminescence emission was monitored by means of a photon counting unit located at the upper side of the immunoreaction cell by collecting the emitted light with a lens. A typical sigmoidal calibration curve was obtained, when the logarithm of the concentration of APnEOs was plotted against the chemiluminescence intensity as the number of photons in 100 ms using standard APnEOs sample solutions at various concentrations (0-1000 ppb) under optimum conditions. The lower detection limit defined as IC(80) is ca 10 ppb. The time required for analysis is less than 15 min per a sample. The present method was successfully applied to the determination of APnEOs in river water.

Chemiluminescence immunoassay for a nonionic surfactant using a compact disc-type microfluidic platform

Efficient ABEI-Dissolved O<sub>2</sub>-Ce(III, IV)-MOF Ternary Electrochemiluminescent System Combined with Self-Assembled Microfluidic Chips for Bioanalysis

Efficient ABEI-Dissolved O 2 -Ce(III, IV)-MOF Ternary Electrochemiluminescent System Combined with Self-Assembled Microfluidic Chips for Bioanalysis.

Sequential injection chemiluminescence immunoassay for nonionic surfactants by using magnetic microbeads

Multiple signal amplification chemiluminescence immunoassay for chloramphenicol using functionalized SiO 2 nanoparticles as probes and resin beads as carriers.

A Simple and Sensitive Flow Injection Chemiluminescence Immunoassay for Chloramphenicol Based on Gold Nanoparticle-Loaded Enzyme

Establishment of an immunoassay for detection of nonylphenols in surfactant oilfield chemicals based on computer-aided design

Highly Sensitive Determination of Diclofenac Based on Resin Beads and a Novel Polyclonal Antibody by Using Flow Injection Chemiluminescence Competitive Immunoassay.

Ultrasensitive Electrochemiluminescent Salbutamol Immunoassay with Dual-Signal Amplification Using CdSe@SiO2 As Label and Gold Nanoparticles As Substrate

Study on Chemiluminescence Assay of Surfactant PEG-400 Using Luminol–Hydrogen Peroxide System

Exploitation of Luminescent Lanthanide Nanoparticles for a Sensitivity-Enhanced ELISA Detection Method

A Study on the System of Nonaqueous Microchip Electrophoresis with On-Line Peroxyoxalate Chemiluminescence Detection.

Ce Immunoassay With Enhanced Chemiluminescence Detection Of Erythropoietin Using Silica Dioxide Nanoparticles As Pseudostationary Phase

Microfluidic flow-injection aptamer-based chemiluminescence platform for sulfadimethoxine detection

Dual-Mechanism Quenching of Electrochemiluminescence Immunosensor Based on a Novel ECL Emitter Polyoxomolybdate-Zirconia for 17 beta-Estradiol Detection

Intelligent onsite dual-modal assay based on oxidase-like fluorescence carbon dots-driven competitive effect for ethyl carbamate detection

All-sealed paper-based electrochemiluminescence platform for on-site determination of lead ions

A General Chemiluminescence Method for the Determination of Surfactants Based on Its Quenching Effect on the Luminol-Naio4-Cyclodextrin Reaction

Electrochemiluminescence of CdSe quantum dots for immunosensing of human prealbumin.

Double-Enzymes-Mediated Bioluminescent Sensor for Quantitative and Ultrasensitive Point-Of-Care Testing

An Integrated Enzyme-Linked Immunosorbent Assay System with an Organic Light-Emitting Diode and a Charge-Coupled Device for Fluorescence Detection.