Abstract:Ultra-wideband (UWB) localization is one of the most promising approaches for indoor localization due to its accurate positioning capabilities, immunity against multipath fading, and excellent resilience against narrowband interference. However, UWB researchers are currently limited by the small amount of feasible open source hardware that is publicly available. We developed a new open source hardware platform, Wi-PoS, for precise UWB localization based on Decawave’s DW1000 UWB transceiver with several unique features: support of both long-range sub-GHz and 2.4 GHz back-end communication between nodes, flexible interfacing with external UWB antennas, and an easy implementation of the MAC layer with the Time-Annotated Instruction Set Computer (TAISC) framework. Both hardware and software are open source and all parameters of the UWB ranging can be adjusted, calibrated, and analyzed. This paper explains the main specifications of the hardware platform, illustrates design decisions, and evaluates the performance of the board in terms of range, accuracy, and energy consumption. The accuracy of the ranging system was below 10 cm in an indoor lab environment at distances up to 5 m, and accuracy smaller than 5 cm was obtained at 50 and 75 m in an outdoor environment. A theoretical model was derived for predicting the path loss and the influence of the most important ground reflection. At the same time, the average energy consumption of the hardware was very low with only 81 mA for a tag node and 63 mA for the active anchor nodes, permitting the system to run for several days on a mobile battery pack and allowing easy and fast deployment on sites without an accessible power supply or backbone network. The UWB hardware platform demonstrated flexibility, easy installation, and low power consumption.

RF front-end for long distance WiFi communication

26.8-M THz Wireless Transmission of Probabilistic Shaping 16-QAM-OFDM Signals

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

Signal Descriptions and Formulations for Long Range Uhf Rfid Readers

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

A Novel Design Method of RF Lens for Long-Range Wireless Power Transmission

A Reconfigurable FM-UWB Transceiver for Short-Range Wireless Communications

System-Level Design Of 60ghz Front-End For Gbps High Speed Wireless Communication

A System Design for the Reader of Microwave Radio Frequency Identification

Low-Power Low-Complexity FM-UWB Hybrid Transceiver for Communication and Ranging

Wi-PoS: A Low-Cost, Open Source Ultra-Wideband (UWB) Hardware Platform with Long Range Sub-GHz Backbone

A 90nm CMOS UHF/UWB Asymmetric Transceiver for RFID Readers

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

A Low-Cost 60-GHz Modular Front-End Design for Channel Sounding

Towards Programmable Backscatter Radio Design for Heterogeneous Wireless Networks

A Low Voltage CMOS RF Front-End for IEEE 802.11b WLAN Transceiver

High-performance dual-band radio-over-fiber link for future 5G radio access applications

A Low-Power Backscatter Modulation System Communicating Across Tens of Meters With Standards-Compliant Wi-Fi Transceivers

An RF Transmitter Front-End Implementation in 0.18&#x03bc;m CMOS for OFDM-UWB

Reconfigurable FM-UWB Transmitter Design for Robust Short Range Communications.

Exploring Multiple Antennas for Long-range WiFi Sensing