Abstract:When measuring the thermal conductivity of thermal insulation materials made by powder metallurgy and building porous materials, complications arise due to the fact that heat flows through the samples are commensurate with heat losses. The steady-state heat flow (SSHF) method is simple, does not require sophisticated equipment, and allows determining the thermal conductivity not in the near-surface layer but in the entire sample volume. Its disadvantage is low accuracy and the need to use reference samples. This work aims to develop an installation for measuring the thermal conductivity of largesized samples of low-conductivity material using the steady-state heat flow method with significantly higher accuracy than existing installations using this method. This is achieved by sandwiching the sample, which is a thin square plate of large dimensions, between the heater chamber and the refrigerator. The heating chamber is made of insulating material and its front wall, which is in contact with the sample, is made of the copper plate (which has good thermal conductivity). In the operating mode, the temperature in the heater chamber is maintained equal to the ambient temperature, which allows us to neglect heat losses and assume that in the steady-state mode, the heater power is equal to the heat flux through the sample. The thickness of the sample is much smaller than the size of its side (the sample should be square). This assumption is necessary to use the condition of isotropic temperature distribution in the cross-section of the sample. The refrigerator is filled with water and ice. The isotropic temperature distribution in the sample is ensured by its contact with the copper walls of the heater and refrigerator chamber. The temperature of the heated surface of the sample is measured using a thermocouple inserted through a hole in the front wall of the heater chamber. The proposed design of the installation and its operating conditions make it possible to significantly improve the accuracy of determining the thermal conductivity coefficient and make the error less than 2%.

A Temperature-Decay Method for Determining Superinsulation Conductivity

A Practical Method to Evaluate the Thermal Efficiency of Solar Molten Salt Receivers

An Experimental Study of Effective Thermal Conductivity of High Temperature Insulations

Heat Sink Equivalent Thermal Test Method and Its Application in Low-Orbit Satellites

Testing Method of Effective Thermal Conductivity of Fibrous Insulations

Variable Temperature Thermal Conductivity and Conductance Measurements Using a Gifford-McMahon Cryocooler

Thermal Conductivity Measurement of the Epoxies and Composite Material for Low Temperature Superconducting Magnet Design

INSTALLATION FOR DETERMINING THE THERMAL CONDUCTIVITY OF PLATES BY THE STATIONARY METHOD

Combination of thermal and electric properties measurement techniques in a single setup suitable for radioactive materials in controlled environments and based on the 3-omega approach

High temperature validation of a line heat source technique for in-pile thermal conductivity determination

Accurate heat capacity determination of solids and liquids using a heat conduction calorimeter

Apparent-Thermal- Conductivity Characterization of Low-Density, Glass-Fiber Insulation Material

Theoretical and Experimental Study on a Compound Insulation System for High Temperature Applications

Ultrahigh Vacuum Cryostat System for Extended Low-Temperature Space Environment Testing

A Detailed Study on the Thermal Endurance of Kapton HN®i and Upilex S®

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Temperature Measurement on Copper Surfaces for Superconducting Thin Film Cavity Applications

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

A high-precision method to measure thermal conductivity of solids using reversible heat flux