Abstract:Chinese FY-4M is a new-generation geosynchronous satellite, which will be launched in the near future. It is equipped with multichannel millimeter wave radiometers, which operate in the range of 50-430 GHz. This satellite will increase revisit time and significantly improve the monitoring and weather variation forecasting capabilities. Calibration is an important issue for the quantitative analysis and application of brightness temperature observations. Calibration is first conducted in a thermal/vacuum chamber prior to the launch. A hot target onboard the satellite is used to provide relative irradiance for onboard calibration, and the cold cosmos is used as a cold target. However, complicated space conditions may result in many uncertainties and instabilities during calibration. A new method is required to evaluate the performance of the instruments during long-term operation. Because of the non-existence of atmospheric and other environmental interferences, the lunar surface maintains its physical and chemical stability. Thus, it is an ideal source for thermal calibration. The earliest ground-based observation of thermal microwave emission of the Moon dates back to the early 1940s. At that time, the temperature profile and dielectric constant of the lunar surface had not been studied in detail. Thus, interpreting the observed microwave brightness temperature was difficult. In recent years, many studies of the lunar surface have been performed owing to the advances in satellite-borne remote sensing programs. The Diviner Lunar Radiometer Experiment onboard the Lunar Reconnaissance Orbiter investigated the global solar reflectance and mid-IR irradiance. These infrared measurements contribute to the quantitative description of the thermophysical properties of the superficial lunar regolith media. Chinese probes, Chang'e-1 and Chang'e-2, carried four-channel microwave radiometers to observe the microwave thermal emission of the lunar regolith media, which may provide information on superficial dielectric properties of the lunar surface. These advances created a foundation for the millimeter channel observation of the lunar surface. In this study, a real-time model of the sub-solar position and total irradiance of the lunar surface was developed. The altitude of FY-4M is 35800 km. The distance between the Moon and the Earth is between 363400 km (perigee) and 405400 km (apogee). This large distance enables nadir observation from the FY-4M radiometer toward the center region of the lunar equator. The observation beam angle ranges from 0.097 degrees to 0.027 degrees. The diameters of the observation regions at different channels are 750 km (55 GHz), 480 km (89, 118 GHz), 300 km (166, 183 GHz), and 210 km (425 GHz) at apogee. Based on the surface albedo derived from the Clementine data and the constrained thermophysical parameters of the lunar regolith media obtained from the Diviner infrared brightness temperature, the one-dimensional thermal transfer equation is solved to obtain the physical temperature profile of the lunar regolith media. Using the 37-GHz brightness temperature from Chang'e-2 observations, the loss tangent of the regolith media is inverted. Using the fluctuation dissipation theorem, the brightness temperature of the lunar surface in FY-4M millimeter channels is calculated. The thermophysical profile of the regolith can be validated using the Diviner infrared brightness temperature data. The calculated temperature at a depth of 1.3 m is consistent with the measurements obtained in the Apollo heat flow experiment. The surface temperature and millimeter brightness temperature on the lunar equator (0 degrees N, 0 degrees E) during the entire year of 2010 are simulated. The peak value of the brightness temperature is attained after that of the surface physical temperature peak value. In the low frequency channel, the penetration depth increases, its peak value is typically small, and the peak appears later. This study thus presents an effective model for FY-4M calibration and data analysis.

An In-Flight Recalibration for Chang’E-1 and E-2 Microwave Radiometer Datasets Based on Highland Thermophysical Models

A Recalibration Model Based on the Statistical Regression Analysis Method to Align the Microwave Data of Chang’E-1 and Chang’E-2

Qualitative Verification of CE-2's Microwave Measurement: Relative Calibration Based on Brightness Temperature Model and Data Fusion

Calibration of the space-borne microwave humidity sounder based on real-time thermal emission from lunar surface

Modeling, Simulation, Inversion and Chang E-1 Data Validation for Microwave Emission Remote Sensing of Lunar Surface Media

Analysis of Microwave Brightness Temperature of Lunar Surface and Inversion of Regolith Layer Thickness:Primary Results of Chang-E 1 Multi-Channel Radiometer Observation

Inversion of Dielectric Properties of the Lunar Regolith Media With Temperature Profiles Using Chang'e Microwave Radiometer Observations

High Frequency Thermal Emission from the Lunar Surface and Near Surface Temperature of the Moon from Chang’E-2 Microwave Radiometer

Average Brightness Temperature of Lunar Surface for Calibration of Multichannel Millimeter-Wave Radiometer from 89 to 183 GHz and Data Validation

Calibration of a multichannel millimeter wave radiometer of FY-4M based on the real-time brightness temperature along the lunar equator

Photometric Correction of Chang’E-1 Interference Imaging Spectrometer’s (IIM) Limited Observing Geometries Data with Hapke Model

Research on Photometric Calibration and Reflectance Calculation of CE-1 IIS Data

The modeling analysis of microwave emission from stratified media of non-uniform lunar cratered terrain surface for Chinese Chang-E 1 observation

Absolute Calibration of the Chang’E-1 IIM Camera and Its Preliminary Application

Inversion of dielectric properties of the Lunar regolith media with temperature profiles using Chinese Chang'E-1 and Chang'E-2 MW observations

Explanations for Unusual Seasonal Variations in Chang’E-2 Microwave Radiometer Datasets of Lunar Double-Shaded Permanently Shadowed Regions

Analysis of high-frequency brightness temperature of lunar surface from chang ’ e-2 microwave radiometer and investigations of mean diurnal temperature of regolith layer

Instrument Overview and Radiometric Calibration Methodology of the Non-Scanning Radiometer for the Integrated Earth–Moon Radiation Observation System (IEMROS)

Using the Moon for On-Orbit Absolute Radiometric Calibration of GaoFen-4 PMS

Evaluation of the Radiometric Calibration of ZY1-02E Thermal Infrared Data

Absolute Radiometric Calibration of PMS2 Onboard Jilin-1 GP02 Satellite Using the Moon