Abstract:In a worldwide scenario which sees an increasing number of small satellite launches, novel mission concepts may be unlocked providing the spacecrafts with the very precise and rapid maneuvering capability that electric thrusters cannot guarantee. In this context, chemical thrusters appear to be a possible solution. This work aimed to experimentally study and solve the problem of ignition for 10 N hybrid rockets based on hydrogen peroxide. Firstly, the study analyzed the performance of a monopropellant engine capable of functioning as a hybrid injection system. In particular, the effects of the liquid mass injected, the initial temperature, and the supply pressure on the pulsed engine performance were experimentally investigated. The injected mass showed a greater impact on the performance with respect to the starting chamber temperature and injection pressure. This thruster also showed a good potential for space applications. In the second part of the work, the objective was to find an ignition procedure that reduced propellant consumption and eliminated the need for a glow plug. This is important because the electrical power consumption in real applications significantly affects other subsystems and is undesirable for chemical engines. Different ignition procedures were tested to emphasize their respective advantages and disadvantages, and the findings indicated that the concept of pulsed preheating is feasible with only a small amount of propellant consumption, while substantially decreasing the ignition duration from approximately 45 min to a maximum of just 3 min. Finally, similar ignition procedures were adopted using different fuels. The results showed that PVC and ABS, under the same operating conditions, ignite more easily than HDPE, which requires an oxidizer consumption approximately double that of the other two fuels. Considerations about the effect of chamber pressure and oxidizer mass flow rate on engine ignition were also included.

Design of Low-Cost Solid Propellant Engine Test Bench and Electronic Embedded System used for Small Rockets

Design, Development, and Performance of an Ammonia Self-Managed Vaporization Propulsion System for Micro-Nano Satellites.

A sounding rocket as a test bench for cost effective measurements: Development of a sounding rocket demonstrator test bench for aerospace technologies and atmospheric measurements

A computational model for the design of a nitrous oxide--paraffin wax hybrid rocket engine

Robust Sensor Optimization for Liquid Propellant Rocket Engine Model Parameter Estimation

Developing a New Tool to Implement Computer-Supported Active Learning Strategies in the Engineering Classroom

Development and Qualification of Green Propellant Micropump for MicroSat and CubeSat Propulsion Systems

A Dual Mode Propulsion System for Small Satellite Applications

Design and Modeling of MEMS-based Solid Propellant Propulsion

Experimental Investigation of N2O-PMMA Lab-Scale Hybrid Rocket Motor

Design and testing of a caseless solid-fuel integral-rocket ramjet engine for use in small tactical missiles.

Development and Laboratory Testing of a CubeSat-Compatible Staged Ionic-Liquid Electrospray Propulsion System

Fuel Ignition in HTP Hybrid Rockets at Very Low Mass Fluxes: Challenges and Pulsed Preheating Techniques Using Palladium-Coated Catalysts

Low-cost, Lightweight Electronic Flow Regulators for Throttling Liquid Rocket Engines

Concept and Key Technology Analysis of Electric Pump-Fed Liquid Propellant Rocket Engine

Design of an Intake and a Thruster for an Atmosphere-Breathing Electric Propulsion System

Design, Optimal Guidance and Control of a Low-cost Re-usable Electric Model Rocket

Dynamic Characteristics of LOX/Kerosene Variable Thrust Liquid Rocket Engine Test System Based on General Modular Simulation Method

Optimization, Test and Diagnostics of Miniaturized Hall Thrusters

Performance Analysis and Mass Estimation of a Small-Sized Liquid Rocket Engine with Electric-Pump Cycle