Abstract:Centrifugal spray deposition forming technology, which is used in the preparation process of near-net-forming billets, not only reduces the macroscopic segregation and refines the microstructures of billets but also has the characteristics of a rapid solidification structure. The trajectory, velocity, heat transfer and solidification of metal droplets granulated by the centrifugal force during flight will affect the shape, precision and microstructure of the billet. Therefore, it is necessary to study the dynamics and thermal history of droplets in flight. In this study, a single droplet is taken as the object. Considering the resistance of ambient gas, Newton's second law, classical nucleation theory, Newton's cooling law and the energy conservation equation were used to establish a dynamic model and heat transfer solidification model of liquid metal droplets during flight. The influence of the centrifugal disc speed on the diameter of granulated droplets was analyzed. The variation law of droplet flight trajectory and velocity was explored. The supercooling degree in metal droplet nucleation was quantified, and the influence of droplet diameter, superheat and other factors on heat transfer and solidification was revealed. The results show that the numerical calculation results are basically consistent with the previous research results. The trajectory of the droplet is parabolic during flight. The initial velocity of the droplet, the environmental gas resistance and the convective heat transfer coefficient are positively correlated with the rotating speed of the centrifugal disc; however, the droplet diameter is negatively correlated with the rotating speed of the centrifugal disc. The super cooling degree at the time of droplet nucleation and the flight time required for solidification are negatively correlated with the droplet diameter. Among them, the droplet diameter has a linear relationship with the solidification start time and a quadratic curve relationship with the solidification end time. The effect of superheat on the heat transfer and solidification of droplets is not obvious. The conclusions obtained can provide a theoretical basis for the determination of the preparation process parameters.

Effect of Atomizer Disc Geometry on Zinc Metal Powder Production by Centrifugal Atomization

The Effect of Suspended Particles on the Corrosion Resistance of Electrodeposited Zinc Powders

Effects of Substrate Geometry on Performance of Twin-Fluid Atomizer in Metal Powder Production

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Nucleation on Thermal History and Microstructural Evolution of Atomized Ti-48Al Nano and Micro-Powders

Impact Mechanism of Gas Temperature in Metal Powder Production Via Gas Atomization

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Simulation and Experimental Investigation of Fe-based Alloy Powder Production by Gas Atomization

Investigation on close-coupled gas atomization for Fe-based amorphous powder production via simulation and industrial trials: Part II. Particle flight and cooling during secondary atomization

Centrifugal Atomization Substrate Quenching Of Rapidly Solidified Particles

Numerical and experimental investigation of close-coupled twin-nozzle gas atomization towards fine high-entropy alloy powder production

Impact of process flow conditions on particle morphology in metal powder production via gas atomization

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Study on Flight Dynamics and Heat Transfer Solidification of Metal Droplets during Centrifugal Spray Deposition Forming Process

Simulation of Supersonic High-Pressure Gas Atomizer for Metal Powder Production

The characterization of the A1-12 Wt Pct Si flake powder produced by a double-disk process

Experimental Study of Zinc Powder Preparation by Electrochemical Method

Influence of temperature on the process of preparing homogenised magnesium-zinc alloy spherical powders using the relative vacuum method

Effect of Particle Size and Shape on Wall Slip of Highly Filled Powder Feedstocks for Material Extrusion and Powder Injection Molding

Numerical investigation on flow process of liquid metals in melt delivery nozzle during gas atomization process for fine metal powder production

Investigation on the Influence of Pressure on Enhancing Atomization Effect of Molten Metal Stream