Abstract:The object of research is high-strength self-compacting concrete, which does not require additional vibration during laying. One of the most problematic issues of high-strength self-compacting concretes is increased cracking, associated with large shrinkage deformations of such concretes and their fragile destruction. A decrease in shrinkage deformations of concrete was established when part of the cement was replaced to mineral additives. This effect is explained by a decrease of the cement content and, accordingly, a decrease of the chemical component of the autogenous shrinkage of concrete, and an increase of the adsorptive binding of capillary moisture by mineral additives, with reduces the physical drying shrinkage of concrete. In this case, the type and dispersion of the used mineral additive can affect to the shrinkage deformations of concrete. A significant decrease in shrinkage deformations when using metakaolin is explained by an increase the amount of ettringite as a result of the reaction of active metakaolin Al2O3 with two-water gypsum of cement. It was found that the replacement of cement to 10 % of mineral additives leads to a decrease in the value of the critical stress intensity factor (SIF), which is compensated by a decrease of the fragility of concrete fracture (an increase of the area of microplastic deformations). At the same time, the type of mineral additive used does not affect to the value of the critical stress intensity factor, but significantly affects to the fragility of fracture of concrete samples. The introduction of 10 % mineral additives (to replace cement) had a positive effect on the retention of flow of self-compacting concrete mixes; the best results according to this criterion were observed when using silica fume, fly ash and limestone. All mineral modifiers, except for silica fume, led to a decrease of the compressive strength of high-strength concretes on all terms of hardening. In the case of the tensile strength of concrete at bending and splitting, with the introduction of silica fume, metakaolin and fly ash, a positive effect was observed compared to the base composition without additives. Comprehensive accounting of the results obtained will allow a reasonable approach to the design of high-strength self-compacting concretes with increased crack resistance.

Increasing the performances of low permeable cement composites

Tailoring the Thermal and Mechanical Properties of Lightweight Cement-Based Composites by Macro and Micro Fillers

Multi-scale Structure of In-Situ Polymerized Cementitious Composites with Improved Flowability, Strength, Deformability and Anti-Permeability

Mechanics, hydration phase and pore development of embodied energy and carbon composites based on ultrahigh-volume low-carbon cement with limestone calcined clay

Optimal Design and Performance of Concrete with Function Component in Marine Environment

Strength, Permeability and Multiscale Pore Characteristics of Cement-Based Materials with High-Volume Fly Ash Contents and Different Water-Binder Ratios

Formulation of low clinker blended cements and concrete with enhanced fresh and hardened properties

Increasing the crack resistance of high-strength self-compacting concrete

Chloride Binding Behavior and Pore Structure Characteristics of Low-Calcium High-Strength Cement Pastes

Study on performance of high strength pumping concrete compounded by fly ash composite powder under low water-cement ratio

Synergistic effect of PTB emulsion, CaCO3 whisker and Nano-SiO2 on the properties of cement-based materials

Inventive Microstructural and Durability Investigation of Cementitious Composites Involving Crystalline Waterproofing Admixtures and Portland Limestone Cement

Water-Resistance Performance Analysis of Portland Composite Concrete Containing Waterproofing Liquid Membrane

Hydration and durability of low-heat cementitious composites for dam concrete: Thermodynamic modeling and experiments

Modified high strength lightweight-aggregate concrete based on expanded clay: composition, structure, properties

MODIFIED COMPOSITE CEMENTS IN THE SYSTEM СаО–Al2O3–SO3–H2O

Examining the early-stage performance and mechanical performance of limestone powder-silica fume binary cement-based materials

Concrete Mix Strength and Permeability with Various Supplementary Cementitious Materials

Durability parameters of three low-carbon concretes (low clinker, alkali-activated slag and supersulfated cement)

Hydration–Strength–Workability–Durability of Binary, Ternary, and Quaternary Composite Pastes

Hydration and microstructure evolution of a novel low-carbon concrete containing recycled clay brick powder and ground granulated blast furnace slag