Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Numerical Study of the Fluid-Structure Interaction During CNT-Water Nanofluid Mixed Convection in a Micro-Channel Equipped with Elastic Fins Under Periodic Inlet Velocity Conditions

Numerical investigation on forced convection in rectangular cross section micro-channels with nanofluids

Numerical study of the optimization of the thermal and flow characteristics of a collector design of microchannels with two inlets and outlets, containing a nanofluid and a water-based fluid

Numerical Study of Three-Dimensional Models of Single- and Two-Phase Nanofluid Flow through Corrugated Channels

Simulation of water/FMWCNT nanofluid forced convection in a microchannel filled with porous material under slip velocity and temperature jump boundary conditions

A Finite Element Simulation of the Active and Passive Controls of the MHD Effect on an Axisymmetric Nanofluid Flow with Thermo-Diffusion over a Radially Stretched Sheet

Three-Dimensional Study of Magnetohydrodynamic Natural Convection, Entropy Generation, and Electromagnetic Variables in a Nanofluid Filled Enclosure Equipped with Inclined Fins

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Numerical investigation of thermal performance augmentation of nanofluid flow in microchannel heat sinks by using of novel nozzle structure: sinusoidal cavities and rectangular ribs

Numerical analysis of forced convection heat transfer in a rectangular micro-channel totally filled with Ag/ water nano fluid in slip flow regime using the lattice Boltzmann method

Numerical Simulation for Impact of Copper/water Nanofluid on Thermo-Convective Instabilities in a Horizontal Porous Annulus

Computational Modelling and Simulations to Study the Thermal Enhancement in Nanofluid Flow in Undulating Wavy Cavity of a Cylinder: Finite Element Analysis

Numerical simulation of nanofluid turbulent flow in a double-pipe heat exchanger equipped with circular fins

Numerical investigation of nanofluid laminar forced convection heat transfer between two horizontal concentric cylinders in the presence of porous medium

Mixed Convection and Entropy Generation Analysis of Carbon Nanotube-Water Nanofluid in a Square Cavity with Cylinders and Flow Deflectors

Comparative studies on heat transfer and flow resistance of nanofluid in microchannels with different sidewall micro-fins

Molecular study on convective heat transfer of nanofluid in nanochannel: effect of CNT particles

NUMERICAL ANALYSIS OF LAMINAR MIXED CONVECTION HEAT TRANSFER OF THE Al2O3–H2O NANOFLUID IN A SQUARE CHANNEL

Numerical computation of CNTs water based nanofluid flow with heat generation/absorption past an oscillating vertical plate with variable temperature

A Computational Fluid Dynamics Study of Laminar Forced Convection Improvement of a Non-Newtonian Hybrid Nanofluid within an Annular Pipe in Porous Media

Numerical investigation of turbulent nanofluid flow behavior in a multi-stream plate-fin heat exchanger with a novel design of fractal fins