Abstract:The mandate assigned by the European Union to the Community Reference Laboratory for residues at the Istituto Superiore di Sanità covers, among other things, the assessment of trace elements in living animals as well as their products. To better protect the health of the consumer, this task aims in particular at harmonizing the procedures in use at the National Reference Laboratories (NRLs) for residues of the Member States for such determinations as well as at developing new approaches wherever the need arises. In this context an investigation was undertaken to appraise the average levels of a number of key elements in several types of honey with special regard to the influence of the various processing steps. Instrumental methods of election for the analysis of this matrix turned out to be inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS) depending on the actual concentrations of the elements of interest. Dissolution of the samples for suitable presentation to the analytical systems could be easily achieved by gentle heating at ca. 50 degrees C, sonication and addition of high-purity water. The ranges ascertained are as follows (in ng g(-1)): As, <0.50-0.70; Cd, <0.50-0.74; Cr, 1.03-3.93; Cu, 144-216; Fe, 191-651; Mn, 223-580; Ni, 17-49; Pb, 3.20-186; Pt, <0.50; Sn, <4-27; V, 1.22-1.94; and Zn, 565-1144. As a rule, concentrations of elements in honey from different beehives were similar. A few exceptions were noted for As, Cu, Fe, Ni and Zn. On the other hand, although data obtained with different analytical approaches for the same types of honey and beehive were generally in good agreement, yet some inconsistencies occurred, as in the case of Cu in freshly collected, extracted and ripened honey, Ni in extracted honey and Fe in ripened honey. These could not be traced back to specific procedural facts; rather, they should be ascribed to the inherent heterogeneity of the raw material. The experience gained with this exploratory study will be exploited to set up wider surveys and to plan the preparation of a new certified reference material in a matrix of honey to the benefit of NRLs for residues.

Optimization of Sample Preparation in the Determination of Minerals and Trace Elements in Honey by ICP-MS

Microwave-induced combustion for further determination of potentially toxic elements in honey by ICP-MS

Determination of essential and potentially toxic trace elements in honey by inductively coupled plasma-based techniques

Trace Elemental Analysis in Honey by Octopole Reaction System Inductively Coupled Plasma Mass Spectrometry

Simultaneous Determination of Aldrin and Mirex in Honey by Liquid–Liquid Extraction with Low-Temperature Purification combined with GC–MS

Determination of Pesticides and Antibiotics in Honey by QuEChERS-HPLC-MS/MS

Study on the simultaneous determination of some essential and toxic trace elements in honey by multi-element graphite furnace atomic absorption spectrometry

Simultaneous Determination of 20 Trace Elements in Different Kinds of Honey by Inductively Coupled Plasma-Atomic Emission Spectrometry

Relationship between geographical origin and contents of Pb, Cd, and Cr in honey samples from the state of Paraná (Brazil) with chemometric approach

Evaluation of the content of macro and trace elements and the geographic origin of honey in North Brazil through statistical and machine learning techniques

Environmentally friendly analysis of sulphonamides in Brazilian honey through automated and miniaturised sample preparation coupled with LC-MS/MS

High-throughput Method Based on a Novel Thin-Film Microextraction Coating for Determining Macrolides and Lincosamides in Honey

Neutron activation analysis and ICP-MS for provenance of honey collected from American Midwest region

Application of Icp-Ms to Detection of Trace Elements and Heavy Metals in Different Kinds of Honey

Chemometric Determination of the Botanical Origin for Chinese Honeys on the Basis of Mineral Elements Determined by ICP-MS

Determination of 5-hydroxymethylfurfural in honey, using headspace-solid-phase microextraction coupled with a polyoxometalate-coated piezoelectric quartz crystal

Analyses of Mineral Content and Heavy Metal of Honey Samples from South and East Region of Turkey by Using ICP-MS

Hydride Generation/Condensation System With an Inductively Coupled Argon Plasma Polychromator for Simultaneous Determination of Arsenic, Antimony, Selenium, Lead, Mercury and Tin in Honey

Mineral and Trace Element Analysis of Australian/Queensland Apis mellifera Honey

Determination Of Multiple Pesticide Residues In Honey Using Gas Chromatography-Mass Spectrometry

A Modified Folin-Ciocalteu Assay for the Determination of Total Phenolics Content in Honey