Preparation and characterization of modified chitosan for in vitro controlled release of vitamin B12

Ahmed Awadallah-F,Tahia B. Mostafa
DOI: https://doi.org/10.1515/polyeng-2013-0094
IF: 1.624
2013-11-01
Journal of Polymer Engineering
Abstract:Abstract Graft copolymerization of acrylonitrile and acryloyl chloride on to chitosan was prepared by γ-rays. Optimization of the grafting (%) was studied. The grafting (%) was observed to increase with increase in the irradiation dose and monomer concentration. The grafting percentages were about 52% and 36% from polyacrylonitrile and poly(acryloyl chloride), respectively. Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) were used to characterize the specimens. The modified chitosan was loaded with vitamin B 12 , demonstrated nearly 5.0±2.3% and 50.1±4.5% release in the media of pH 1.2 and 6.8, respectively, for amidoximated chitosan-grafted polyacrylonitrile and 3.6±1.1% and 36±2.4% in pH 1.2 and 6.8, respectively, for chitosan-grafted poly(acryloyl chloride), as determined by a traditional dissolution model. The modified chitosan specimens that uploaded with vitamin B 12 displayed a more decremental release in the acidic medium than the neutral one. However, in order to incorporate in vivo gastrointestinal conditions, such as acidic pH and high water content in the stomach, low water content, and the presence of semi-solid mass in the large intestine, a new model, called flow through diffusion cell, was also used to study the drug release. The results of the two approaches produced different release profiles at the same pH values.
polymer science
What problem does this paper attempt to address?