Abstract:Abstract For a gear pair, both the contact pattern and the transmission error (TE) significantly impact durability and fatigue life. Design and manufacturing processes are often aimed at improving the contact pattern and reducing the overall TE. Other errors, such as runout and wobble, are often induced during the installation of power transmission systems, and they can alter the contact pattern and TE of an otherwise well-designed gear pair. This study provides a methodology to experimentally investigate the impact of wobble errors on the contact pattern and static transmission error (STE) of helical gears. It first provides a description of the modifications to an existing test machine. Next, it describes the gear specifications, preliminary testing matrix, data acquisition and processing procedure, as well as the experimental results obtained with regards to both the contact pattern and STE. The following are observed while describing the experimental results. For a test with no wobble and no runout, the contact pattern remains the same at every rotational position. However, by introducing even a small amount of wobble, the contact will shift from one side of the face width of the gear to the opposite side of the face width of the gear within one revolution. Introduction of wobble may increase the STE and sideband activity around gear mesh harmonics, especially as torque increases. Yet the modest increases in STE and sideband activity seen with the introduction of wobble are not enough to make definitive conclusions. The feasibility of the modified test setup has been demonstrated, and preliminary results have been presented. However, additional data collection should be completed in order to study the impact of runout and wobble on both spur and helical gear pairs with various microgeometry modifications and manufacturing errors.

A Novel Gear Test Rig with Adjustable Shaft Compliance and Misalignments Part I: Design

A Novel Gear Test Rig with Adjustable Shaft Compliance and Misalignments. Part II: Instrumentation

Research on Test System of Comprehensive Transmission Performance of Wide-range Gears

Evolutional development & design of an adjustable single gear tooth testing procedure for polymer gearing

The Influence of Coupling Misalignment on Dynamic Characteristics of Helical Gear System

Simulation Analysis of a Novel Magnetic Gear

Test Rig for Spline Couplings Working in Misaligned Conditions

Dynamic behavior of a power re-circulating gear test rig including periodic variation of mesh stiffness and static transmission error

An experimental and theoretical study of the dynamic behavior of double-helical gear sets

An Experimental Study on High Speed Helical Gears Misalignments and Dynamic Behavior under Random Loading

A New Design of the Universal Test Rig to Measure the Wear Characterizations of Polymer Acetal Gears (Spur, Helical, Bevel, and Worm)

Test Rig for The In Situ Measurement of The Elastic Tooth Deflection of Plastic Gears

Design and Development of a Planetary Gearbox for Electromechanical Actuator Test Bench through Additive Manufacturing

A Methodology to Experimentally Investigate the Impact of Wobble Errors on the Contact Pattern and Static Transmission Error of Helical Gear Pairs

Dynamic modeling and experimental verification of electric-drive axle considering real gear mesh misalignment

Efficiency of Bevel and Hypoid Gears—Test Rig Development and Experimental Investigations

Static and Dynamic Transmission Error Measurements of Helical Gear Pairs With Various Tooth Modifications

Design of novel test rig for prosthetic finger distal interphalangeal and phalanx strengths

Development of a new gear profile measuring machine with five-link closed-loop mechanism

DESIGN OF TORQUE TESTING SETUP FOR SHAFT HAVING SPLINES AT TWO ENDS

Simulation and experimental test of load-sharing behavior of planetary gear train with flexible ring gear