Carbon-coated Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 nanoparticles as a novel anode material for high energy density lithium-ion batteries
Khadija Kouchi,Marwa Tayoury,Abdelwahed Chari,Loubna Hdidou,Zakaria Chchiyai,Khadija El kamouny,Youssef Tamraoui,Bouchaib Manoun,Jones Alami,Mouad Dahbi
DOI: https://doi.org/10.1039/d4cp00182f
IF: 3.3
2024-02-16
Physical Chemistry Chemical Physics
Abstract:Lithium-ion batteries (LIBs) have gained considerable attention from the scientific community due to their outstanding properties, such as high energy density, low self-discharge, and environmental sustainability. Among the prominent candidates for anode materials in next-generation LIBs are the spinel ferrites, represented by the MFe 2 O 4 series, which offer exceptional theoretical capacities, excellent reversibility, cost-effectiveness, and eco-friendliness. In the scope of this study, Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 nanoparticles were synthesized using a sol–gel synthesis method and subsequently coated with a carbon layer to further enhance their electrochemical performance. TEM images confirmed the presence of the carbon coating layer on the Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 /C composite. The analysis of the measured X-ray diffraction (XRD) and Raman spectroscopy results confirmed the formation of nanocrystalline Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 before coating and amorphous carbon in the Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 /C after the coating. The Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 anode material exhibited a much higher specific capacity than the traditional graphite material, with initial discharge/charge capacities of 1275 and 874 mA h g −1 , respectively, at a 100 mA g −1 current density and a first coulombic efficiency of 68.54%. The long-term cycling test showed a slight capacity fading, retaining approximately 85% of its initial capacity after 75 cycles. Notably, the carbon-coating layer greatly enhanced the stability and slightly increased the capacity of the as-prepared Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 . The first discharge/charge capacities of Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 /C at 100 mA g −1 current density reached 1032 and 723 mA h g −1 , respectively, and a first coulombic efficiency of 70.06%, with an increase of discharge/charge capacities to 826.6 and 806.2 mA h g −1 , respectively, after 75 cycles (with a capacity retention of 89.7%), and a high-rate capability of 372 mA h g −1 at 2C. Additionally, a full cell was designed using a Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 /C anode and an NMC811 cathode. The output voltage was about 2.8 V, with a high initial specific capacity of 755 mA h g −1 at 0.125C, a high rate-capability of 448 mA h g −1 at 2C, and a high-capacity retention of 91% after 30 cycles at 2C. The carbon coating layer on Ni 0.5 Mg 0.5 Fe 1.7 Mn 0.3 O 4 nanoparticles played a crucial role in the excellent electrochemical performance, providing conducting, buffering, and protective effects.
chemistry, physical,physics, atomic, molecular & chemical