Abstract:Cylindrical gear with variable hyperbolic circular arc tooth trace (VH-CATT) is a new type of gear. Sliding wear is the main mode of the surface failure of multiple mechanical parts. Both the lubrication state and contact temperature considerably influence wear characteristics, which may aggravate the transmission performance of gear pairs. Wear, contact temperature, as well as lubrication states are jointly explored. Therefore, an integrated wear prediction model was proposed through taking into account flash contact temperature and surface roughness of VH-CATT cylindrical gears in mixed elastohydrodynamic lubrication. According to the equivalent ellipse contact model of VH-CATT cylindrical gears and tooth surface equation, normal curvature and velocity relations for VH-CATT cylindrical gears were observed, and the normal meshing force was obtained through the consideration of load sharing coefficients and quality grades. Flash contact temperature was estimated by using the literature. This study proposes analytical solutions for investigating how various surface roughness, operation, and geometric parameters affect asperity contact ratio (ACR), asperity contact pressure (ACP), flash contact temperature (FCT), as well as wear depth (WD) related to driving gears. ACR, ACP, FCT, as well as WD initially decrease and then increase from engaging-in to engaging-out processes. The minimum occurs at the pitch point. The WD declines as module, cutter radius, and rotational velocity increase while augmenting when surface roughness and torques increase. The maximum and minimum wear depths in driving gears occur at the dedendum and pitch point, respectively. Its overall wear is reduced by 23.16 % compared to the wear of spur gears. The results are valuable for the studies of tooth pitting, wear resistance, and fatigue life improvement for VH-CATT cylindrical gear. These studies can provide verification data and references required for engineering designs and VH-CATT cylindrical gear operations.

Calculation of gear tooth flank surface wear during an FZG micropitting test

Surface damage prediction during an FZG gear micropitting test

Influence of gear surface roughness on the pitting and micropitting life

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

In situ measurement of gear tooth profile during FZG gear micropitting test

A model to study the effect of micropitting on the dynamic behaviour of a geared system

The Influence of Pulling Up on Micropitting Location for Gears with Interference Fit Connections of Their Conical Surface

Improving applied roughness measurement of involute helical gears

Wear Mechanisms of the Working Surface of Gears after Scuffing Tests

Prediction of Surface Wear of Involute Gears Based on a Modified Fractal Method

Identification of failure modes of a PEEK-steel gear pair under lubrication

Evolution of tooth surface morphology and tribological properties of helical gears during mixed lubrication sliding wear

Numerical simulation of wear-mechanism maps

Gear Tooth Root Fatigue Behaviour

Predicting Film Parameter and Friction Coefficient for Helical Gears Considering Surface Roughness and Load Variation

A computational model of wear evolution for shot peened surfaces of gear steel

Influence of Surface Micro-Texture on the Tribological Properties of Heavy-Duty Gears

On the interest of a semi-empirical model for the tooth friction coefficient in gear transmissions

Gear Wear Prediction Based on the Theorem of Degradation Entropy Generation

Modification methodology of fretting wear in involute spline

Integrated wear prediction model for cylindrical gear with variable hyperbolic circular arc tooth trace under mixed elastohydrodynamic lubrication