Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

Study on Applicability of Double Layer Superimposed Primary Support Arch Cover Method for Large-Span Station in Upper Soft and Lower Hard Stratum

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

Study on adaptability of primary support arch cover method for large-span embedded tunnels in the upper-soft lower-hard stratum

Model experiment and support optimization analysis of primary support arch cover excavation of large-section metro station in sandy mudstone stratum

Analysis for Ground Deformation Induced by Undercrossed Shield Tunnels at a Small Proximity Based on Equivalent Layer Method

Influence of the Large-Span Pile-Beam-Arch Construction Method on the Surface Deformation of a Metro Station in the Silty Clay–Pebble Composite Stratum

Study on the Influence of Blasting Construction of Double-Layer Superimposed Primary Support Arch Cover Method on the Surrounding Environment

Arch foot stability for a large-span metro station crossing a fault fracture zone by the arch cover method

Investigation on the Influence of Active Underpinning Process on Bridge Substructures During Shield Tunnelling: Numerical Simulation and Field Monitoring

Primary support optimization of large-span and shallow buried hard rock tunnels based on the active support concept

Field Measurement Analysis of the Influence of Double Shield Tunnel Construction on Reinforced Bridge

Effect of Excavation Blasting in the Arch Cover Method on Adjacent Existing Pipelines in a Subway Station

Research on the Mechanism of Load Transfer Structures in the Construction Process of "Internal Support—Large Block" Prefabricated Subway Stations

Study on ground settlement and structural deformation for large span subway station using a new pre-supporting system

Analysis of Arch Forming Factors of Shallow Buried Hard Rock Tunnel under Overlying Load

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Enlarging a Large-Diameter Shield Tunnel Using the Pile–Beam–Arch Method to Create a Metro Station

Influence of Pile Foundation Construction on Existing Tunnels in a Metro Protection Area: Field Test and Numerical Simulation

Control of Strata Deformation in Subway Interval Tunnels Crossing a High-Speed Rail Shield Tunnel at a Short Distance

Research of surface settlement for a single arch long-span subway station using the Pipe-roof Pre-construction Method

Analysis of the influence of super large area and super deep foundation pit excavation construction on surrounding subways