Abstract:Hydrogen represents a promising renewable fuel, and its broad application can lead to drastic reductions in greenhouse gas emissions. Keeping hydrogen in liquid form helps achieve high energy density, but also requires cryogenic conditions for storage as hydrogen evaporates at temperatures of about 20 K, which can lead to a large pressure build-up in the tank. This paper addresses the unsteady thermal modeling of cryogenic tanks with liquid hydrogen. Considering the liquid and vapor phases in the tank as two nodes with averaged properties, a lumped-element method of low computational cost is developed and used for simulating two regimes: self-pressurization (also known as autogenous pressurization, or pressure build-up in the closed tank due to external heat leaks) and constant-pressure venting (when some hydrogen is let out of the tank to maintain pressure at a fixed level). The model compares favorably (within several percent for pressure) to experimental observations for autogenous pressurization in a NASA liquid hydrogen tank. The two processes of interest in this study are numerically investigated in tanks of similar shapes but different sizes ranging from about 2 to 1200 m3. Pressure and temperature growth rates are characterized in closed tanks, where the interfacial mass transfer manifests initial condensation followed by more pronounced evaporation. In tanks where pressure is kept fixed by venting some hydrogen from the vapor domain of the tank, the initial venting rate significantly exceeds evaporation rate, but after a settling period, magnitudes of both rates approach each other and continue evolving at a slower pace. The largest tank demonstrates a six-times-lower pressure rise than the smallest tank over a 100 h period. The relative boil-off losses in continuously vented tanks are found to be approximately proportional to the inverse of the tank diameter, thus generally following simple Galilean scaling with a few percent deviation due to scale effects. The model developed in this work is flexible for analyzing a variety of processes in liquid hydrogen storage systems, raising efficiencies, which is critically important for a future economy based on renewable energy.

Thermomechanics of a metal hydride-based hydrogen tank

Thermomechanics of hydrogen storage in metallic hydrides: modeling and analysis

Thermodynamics Study of Hydrogen Storage Materials

Theoretical investigation on heat leakage distribution between vapor and liquid in liquid hydrogen tanks

Modeling Heat and Mass Transfer in Metal Hydride-Based Hydrogen Storage Systems Using the Finite Volume Method

Thermodynamic Analysis of the Effect of Initial Ortho-Hydrogen Concentration on Thermal Behaviors for Liquid Hydrogen Tanks

Modeling and thermodynamic analysis of thermal performance in self-pressurized liquid hydrogen tanks

Thermal Models for Self-Pressurization Prediction of Liquid Hydrogen Tanks: Formulation, Validation, Assessment, and Prospects

Thermo-mechanical Investigation of Composite High-Pressure Hydrogen Storage Cylinder During Fast Filling

Thermodynamic Analysis of Partially Filled Hydrogen Tanks in a Wide Scale Range

Perspective for the Safe and High-Efficiency Storage of Liquid Hydrogen: Thermal Behaviors and Insulation

A 70 MPa Hydrogen-Compression System Using Metal Hydrides

Thermal model development and validation for rapid filling of high pressure hydrogen tanks

Thermal transport of charging/discharging for hydrogen storage in a metal hydride reactor coupled with thermochemical heat storage materials

Numerical Simulation on Heating Effects during Hydrogen Absorption in Metal Hydride Systems for Hydrogen Storage

Numerical simulation and experimental validation of Ti0.95Zr0.05Mn0.9Cr0.9V0.2 alloy in a metal hydride tank for high-density hydrogen storage

Metal Hydride Storage Systems: Approaches to Improve Their Performances

Thermodynamic and heat transfer models for refueling hydrogen vehicles: Formulation, validation and application

The Effect of Liquid Hydrogen Tank Size on Self-Pressurization and Constant-Pressure Venting

Generalized thermodynamic modeling of hydrogen storage tanks for truck application

Conception and numerical simulation of heat and mass transfer in a solid state hydrogen storage reactor