Abstract:An infrared laser‐assisted direct ink writing process is developed to fabricate high‐fidelity polydimethylsiloxane (PDMS) structures with commercial thermally cured DOWSIL‐SE1700. The accelerated cross‐linking reaction arising from the irradiation energy of the laser significantly improves the collapse of large‐span architecture. The in situ preheating process also facilitates the fabrication of complex structures with thin wall features, exhibiting promising 3D printing capability. Polydimethylsiloxane (PDMS) is extensively applied in the 3D printing field due to its excellent biocompatibility, flexibility, and gas permeability. However, as a thermal curing material, its low strength before curing inevitably causes structural deformation during the printing process and deteriorates the shape accuracy. In this paper, an innovative method, the infrared laser‐assisted direct ink writing (DIW) process, is developed to realize the in situ preheating and curing of silicone materials to improve the strength of PDMS filaments during processing. Therefore, the large‐span spatial structure with high‐fidelity morphology can be produced. First, the feasibility is validated that temperature ascension of the voxels arising from the irradiation energy of the infrared laser can accelerate the cross‐linking reaction and realize the precuring of PDMS; then, the relationship between the parameters of laser irradiation and the processing performance of 3D printing is systematically investigated to find the optimization. Finally, experiments are conducted, including the single silicone filament, silicone foams, and complex 3D features. Their excellent structural preservation proves the proposed method is practical to fabricate the high‐fidelity fabrication of complex structures such as large spans and thin wall features, which will help to broaden the 3D printing capabilities of silicone in the development of flexible electronics and soft robots.

Self-assembled micro-organogels for 3D printing silicone structures

Dimethyl Sulfoxide Mediated High-Fidelity 3D Printing of Hydrogels

3D freeform printing of silk fibroin

Instant Gelation System As Self-Healable and Printable 3D Cell Culture Bioink Based on Dynamic Covalent Chemistry.

3D embedded printing of microfluidic devices using a functional silicone composite support bath

Multi-Material 3D Printing of Highly Stretchable Silicone Elastomer.

Microfabrication of 3D-Polymeric Structures Using Soft Lithography for Tissue Engineering

A silicone-based support material eliminates interfacial instabilities in 3D silicone printing

Cost-Effective 3D Printing of Silicone Structures Using an Advanced Intra-Layer Curing Approach

3D Printing by Multiphase Silicone/Water Capillary Inks

Direct ink writing of silicone elastomers to fabricate microfluidic devices and soft robots

Directed assembly of cell-laden microgels for building porous three-dimensional tissue constructs.

Directed Assembly of Cell-Laden Microgels for Fabrication of 3D Tissue Constructs.

Solvent‐Independent 3D Printing of Organogels

Surface-directed assembly of cell-laden microgels.

Mesoscopic Supramolecular Assembly of Stereolithographically Printed Microgels

All-Silicone 3D Printing Technology: Toward Highly Elastic Dielectric Elastomers and Complex Structures

Laser‐Assisted Direct Ink Writing for High‐Fidelity Fabrication of Elastomeric Complex Structures

Novel Fast Cure Silicone Inks for Single‐Step, Support‐Free 3D Printing of Tall, Overhanging, and High Aspect Ratio Structures

On-Chip Fabrication and In-Flow 3D-Printing of Cell-Laden Microgel Constructs: From Chip to Scaffold Materials in One Integral Process

3D printing of self‐standing and vascular supportive multimaterial hydrogel structures for organ engineering