Abstract:Abstract The research is aimed at assessing the possibility of studying the ash content of coal seams using neutron-neutron logging in coal exploration wells drilled at the outcrops of coal seams under loose deposits using the materials of experimental work in the South Yakutsk coal basin. The prospects of using neutron-neutron logging to study coal well sections, on the one hand, is determined by the fact that hydrogen content in coal seams normally exceeds its content in the host rocks, and, on the other, by the small cross-sections of neutron capture by carbon. Within the same coal grade, an increase in its ash content both means a decrease in its hydrogen content and an increase in the content of elements with a higher capture cross section. Experimental studies were carried out at the Syllakh coal deposit. An IBN-8-1 type plutonium-beryllium source with an output of 5*10 4 neutrons/s was used as a fast neutron source, and a highly efficient SNM-17 type helium gas-discharge counter was used as a slow neutron detector. The logging depth provided by the equipment was 10 - 30 cm. During the processing of the obtained field data, a correlation was established between the count rate of neutron-neutron logging and coal ash content. It should be noted that the functional dependence of the count rate of neutron-neutron logging on ash content is not continuous – in the range of ash content of 45 - 55% a certain discontinuity point is observed, after which the functional dependence changes. To simplify the assessment of the dependence, the range of rock ash content above 45% is neglected since bituminous coals with an ash content of more than 45% are classified as carbonaceous rock and are not of industrial interest. A close correlation is established between the count rate of neutron-neutron logging and coal ash content. According to the results of statistical processing, the correlation coefficient is 0.97, which makes it possible to quantitatively determine the ash content according to neutron-neutron logging data. The absolute errors in ash content determination by neutron-neutron logging over the entire dataset are up to 3.625 %. The degree of analytical moisture influence on the data of neutron-neutron logging in determining coal ash content is estimated. No regular changes in the count rate of neutron-neutron logging due to a change in the analytical moisture index have been established. It is noteworthy that, with a sufficiently large dispersion value of the analytical moisture index, the trend line of this parameter regularly changes synchronously with the trend lines of ash content and count rate.

Solid fuel quality control by the pulsed neutron–gamma method

Examination of Industrial Demonstration Unit of Coal Gasification for Pulverized Coal with Ash Agglomeration Technique

Ultrafine Particle Formation in Pulverized Coal, Biomass, and Waste Combustion: Understanding the Relationship with Flame Synthesis Process

Measurement and Numerical Simulation of Ultrafine Particle Size Distribution in the Early Stage of High-Sodium Lignite Combustion

Chemical Characterization of Coal: Quality Control and Applications of Nuclear Analytical Methods Utilizing Neutrons (Thermal and Fast) and Low Energy Protons from Accelerators

Implication of nuclear analytical techniques for the assessment of coal quality in terms of ash content

On-line Tracking of Pulverized Coal and Biomass Fuels Through Flame Spectrum Analysis

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Comparison of the Analytical Performance of Inductively Coupled Plasma Mass Spectrometry and Instrumental Neutron Activation Analysis Techniques in the Elemental Analysis of Coal Fly Ash

Determination of pit-coal ash content with the use of an (α, n) neutron source

Determination of Moisture Content in Coal using Pulsed Fast Thermal Neutron Activation Technique

Portable Digital Holographic Particle Analyzer (DHPA) for Pneumatically Conveyed Fuel Monitoring: Design and Validation

Flamelet Tabulation Methods for Solid Fuel Combustion with Fuel-Bound Nitrogen

Determination of Coal Ash Content by Neutron-Neutron Logging

Kinetic Study on Co-Combustion of Pulverized Anthracite and Bituminite for Blast Furnace Injection

Rapid Classification and Measurement of Coal Quality for Power Plant based on NIR Technology

Measurements and Modelling of Oxy-Fuel Coal Combustion

The Investigation of Carbon Content in Fly Ash for a BP Neural Network-based Pulverized Coal-fired Boiler

Pile-Up Correction for Inelastic Gamma-Ray Detection in Pulsed Fast Neutron Analysis

Optimization of PGNAA device and algorithm for testing basicity index of sinter mixture

Simulation Study of the Channel on Correcting Neutron Self-Shielding Effect in Bulk Coal