Optimization of a vertical axis wind turbine for application in an urban/suburban area

Lam Nguyen,Meredith Metzger

DOI: https://doi.org/10.1063/1.4994574

IF: 2.847

2017-07-01

Journal of Renewable and Sustainable Energy

Abstract:The goal of this study is to investigate the effect of various design parameters on the performance of a Vertical Axis Wind Turbine (VAWT) subjected to realistic unsteady wind conditions. Thirteen turbine design configurations are examined to determine if an optimal VAWT has applications in an urban/suburban environment. The four design parameters of interest include the height-to-diameter aspect ratio (0.83≤H/D≤1.34), blade airfoil shape (NACA 0012, 0015, 0018), turbine solidity (12≤S≤25%), and turbine moment of inertia. The height and diameter of the turbine varied between 1.89 and 2.54 m, depending on the aspect ratio. The turbine moment of inertia was calculated using a computer-aided design drawing of the turbine, along with the realistic material properties of blades, shafts, and supports. The energy generated by each VAWT design configuration is simulated using a full year of actual wind speed data collected in 2009 at 9 different locations around Oklahoma City spanning an area of approximately 500 km2. The wind data were acquired from the top of traffic light posts at a height of about 9 m above the ground. In all cases, an active control strategy is used that allows the turbine to continuously adjust its rotational speed in response to the fluctuating wind. The results suggest that, for the case of operation in unsteady winds, the optimal power coefficient (Cp) versus tip speed ratio curve is not necessarily the one exhibiting the highest peak Cp value but rather the broadest shape. Of the thirteen configurations examined, the optimal wind turbine design capable of harvesting the most energy from the gusty winds was found to have an aspect ratio of H/D=1.2, a solidity of S=12%, and a blade shape using the NACA 0015 airfoil. This design also displayed the lowest moment of inertia. However, when the effects of mass were removed, this design still performed the best. The site-to-site variation in terms of energy captured relative to the available energy in the gusty winds was only about 5% on average and increased slightly with turbine moment of inertia. Four of the suburban sites studied were deemed to be economically viable locations for a small-scale VAWT. The results further indicate that, at one of these sites, the levelized cost of energy associated with the top performing turbine designs examined in the study was about 10% less than the national electricity price, meaning that wind energy provides a cheaper alternative to fossil fuel at this location. It is surmised that VAWTs could economically harvest wind energy in the urban center as well if the turbines were located higher than 9 m, such as on the rooftops of commercial/residential buildings.

energy & fuels,green & sustainable science & technology