Abstract:Additively manufactured (AM) components' surface finishing is crucial in adopting them for intended applications in challenging environments involving fatigue, corrosion, high temperature, and nuclear radiation. In our prior research, chempolishing (C) was utilized as an electroless etching process that uniformly smoothens complex AM components' accessible interior and exterior surfaces (Tyagi et al. Additive Manufacturing, 25:32–38, 22). A wide range of electropolishing (E) has been demonstrated for AM surface finishing. However, electropolishing can impact a surface that can be juxtaposed to counter electrode and can yield a very smooth surface to sub-micrometer level roughness. However, a knowledge gap exists about the impact of applying both approaches on the same surface one after another and what new advantages may arise because of combining two methods. This paper uses dual-stage liquid-based surface finishing strategies produced by alternating the chempolishing (C) and electropolishing (E) steps. Two dual-stage surface finishing approaches, i.e., chempolishing followed by electropolishing (CE) and electropolishing followed by chempolishing (EC), were performed on the 316 stainless AM steel component. Impacts of EC and CE approaches were compared with single-stage C and E surface finishing approaches. An optical microscope and mechanical profilometer were utilized to investigate the wide range of surface roughness parameters. CE and EC produced Ra ~ 1.4 μm and ~ 1.6 μm, respectively. Surface roughness on CE- and EC-treated AM samples was lower than those individually treated by C and E approaches. Scanning electron microscopy provided further insights into the microstructural difference between CE- and EC-treated AM samples. This paper reports a liquid contact angle study on CE- and EC-treated AM samples to provide insights into the relative difference in surface energy that is crucial for making coatings on AM parts. A spectroscopic reflectance study was also employed to register the difference in physical properties of AM components treated with CE and EC approaches. This study reveals industrially practicable interior and exterior surface finishing approaches for complex AM metal components that require minimum tooling and real-time process monitoring.

Critical review of electrochemical honing: sustainable and alternative gear finishing process. Part 2: effects of various process parameters on surface characteristics and material removal rate

State-of-art-review of electrochemical honing of internal cylinders and gears

Experimental investigations on surface finish and microgeometry of helical gear in pulsed-electrochemical honing process

High-Speed and Low-Noise Gear Finishing by Gear Grinding and Honing: A Review

Evolution of electrochemical finishing processes through cross innovations and modeling

Implementation of tool and electrolyte-based development in the ultrasonic-assisted ECDM process: a review

Recent trends on electro chemical machining process of metallic materials: a review

Advancements in surface finish for additive manufacturing of metal parts: a comprehensive review of plasma electrolytic polishing (PEP)

Review—Electropolishing of Additive Manufactured Metal Parts

Improvement of process performance of powder mixed electrical discharge machining by optimisation -A Review

State of the art review on the sustainable dry machining of advanced materials for multifaceted engineering applications: Progressive advancements and directions for future prospects

Influences of tooth flank finishing after fine particle shot peening on tooth surface texture and fatigue life of vacuum carbonitrided gears

Multi-response optimization in face milling of EN-31 steel using analytical hierarchy process-based GRA

Alternating chempolishing and electropolishing for interior and exterior surface finishing of additively manufactured (AM) metal components

A Hybrid-Electrochemical Magnetorheological (H-ECMR) Finishing Process for Surface Enhancement of Biomedical Implants

Application of sustainable techniques in grinding process for enhanced machinability: a review

Review—Electrochemical Discharge Machining: Gas Film Electrochemical Aspects, Stability Parameters, and Research Work

Review on alternative approaches to fabricate the Copper based Electric Discharge Machining (EDM) electrodes

Study of machining performance for electrochemical grinding of difficult-to-cut alloy U71Mn

Reviewing Performance Measures of the Die-Sinking Electrical Discharge Machining Process: Challenges and Future Scopes

Electric discharge machining performance measures and optimisation: a review