Abstract:The evolution of phase composition and mechanical properties and the formation of oxide layers on Fe40–xNiCoCrAlx (x = 5 and 10 at.%) alloys in long-term oxidation at 900 and 1000°C were studied. In the initial cast state, depending on the aluminum content and valence electron concentration, the alloys contain only an fcc solid solution (VEC = 8 e/a) or a mixture of fcc and bcc phases (VEC = = 7.75 e/a). Thin continuous oxide scales containing Cr2O3 and NiCr2O4 spinel formed on the surface of both alloys oxidized at 900°C for 50 h. A further increase in the annealing time to 100 h leads to the formation of aluminum oxide Al2O3 in the scale on the Fe30Ni25Co15Cr20Al10 alloy, having high protective properties. An increase in the oxidation temperature to 1000°C results in partial failure of the protective layer on the alloy with 10 at.% Al. Long-term holding at 900°C (100 h) + 1000°C (50 h) does not change the phase composition of the Fe35Ni25Co15Cr20Al5 alloy matrix, being indicative of its high thermal stability. In the two-phase Fe30Ni25Co15Cr20Al10 alloy, the quantitative ratio of solid solutions sharply changes: the amount of the bcc phase increases from 4 to 54 wt.% and its B2-type ordering is observed. The mechanical characteristics of the starting alloys and those after long-term high-temperature annealing were determined by automated indentation. The hardness (HIT) and elastic modulus (E) of the cast Fe35Ni25Co15Cr20Al5 alloy are equal to 2 and 147 GPa, respectively, and decrease to 1.8 and 106 GPa after a series of long-term annealing operations. The Fe30Ni25Co15Cr20Al10 alloy shows the opposite dependence: HIT increases from 2.5 in the initial state to 3.1 GPa after annealing and E decreases from 152 to 134 GPa. This indicates that the Fe30Ni25Co15Cr20Al10 alloy is promising as a high-temperature oxidation-resistant and creep-resistant material.

Characterization of refractory steel oxidation at high temperature

Isothermal short‐term oxidation behavior of MAR‐M246 nickel‐based superalloy at 800°C and 1000°C

ISOTHERMAL OXIDATION BEHAVIOR OF A SINGLE CRYSTAL NICKEL-BASED SUPERALLOY

Chromium Depletion in a Ni-30Cr Alloy During High-Temperature Oxidation

High temperature oxidation behavior of alumina-forming austenitic stainless steel

High-temperature oxidation behaviour of nanostructure surface layered austenitic stainless steel

Structural State of High-Entropy Fe40–xNiCoCrAlx Alloys in High-Temperature Oxidation

Oxidation of a 4 wt.% Hf-containing nickel-based alloy at temperatures ranging from 1100°C to 1250°C in air

Current Status of Research on the Oxidation Behavior of Refractory High Entropy Alloys

Influence of microstructure on the oxidation behaviour of the Ni-based single crystal superalloy AM1 between 850 and 1050 °C in air

Phase equilibria, microstructure, and high temperature oxidation resistance of novel refractory high-entropy alloys

Oxidation of Thin Nickel-Based Superalloy Specimens: Kinetics Study and Mechanical Integrity

Understanding the high-temperature oxidation resistance of heat-resistant austenitic stainless steel with gradient nanostructure

High temperature oxidation behavior of a novel Ni-Cr-W-Al-Ti superalloy

Analysis of Oxide Layer Formation During Oxidation of AISI 4140 Steel at 1000 °C over Exposure Time

Oxidation behavior of the Ti38V15Nb23Hf24 refractory high-entropy alloy at elevated temperatures

Microstructural understanding of high-temperature oxidation behaviour of selective laser melted Inconel 718 superalloy in CO 2 atmosphere

Microstructural understanding of the oxidation of an austenitic stainless steel in high-temperature steam through advanced characterization

High-Temperature Oxidation Behavior of Refractory High-Entropy Alloys: Effect of Alloy Composition

Oxidation behaviour and microstructure evolution of Zr-containing steel under continuous high-temperature exposure

Isothermal Oxidation Resistance of As-cast NiAl and NiAl-(Cr, Mo) Eutectic Alloys at 1000°C