Abstract:In this paper, we report a new design of an all-optical filter using photonic crystal microstructure. Ring resonators, line defects, scatterer rods, microcavities, and coupling rods are used to form the filter in order to extract specific wavelengths at the output channels. The well-known plane wave expansion method is used to calculate the photonic band diagram. The widely used finite-difference time-domain method is also applied to study the light propagation inside the filter. Our numerical results demonstrate that the proposed structure has high transmission power, high-quality factor, and low cross-talk. They reveal an optical signal centered at 1522 nm exits the first output channel, which has an output-to-input ratio (OIR) of 95 % with a bandwidth (FWHM) of 0.4 nm, and an optical signal centered at 1520.8 nm exits the second output channel with an OIR of 98 % and an FWHM of 0.5 nm. The third output channel can exit the optical signal centered at 1518.2 nm with an OIR of 78 % and an FWHM of 0.4 nm. Furthermore, the fourth channel will exit the optical signal at 1519.3 nm with an OIR of 56 % and an FWHM of 0.4 nm. Therefore, the quality factors of the first to fourth outputs of the filter are equal to 3805, 3041, 3795, and 3798, respectively. The first to fourth outputs' cross-talk values are also − 37 dB, − 36 dB, − 41 dB, and − 38 dB, respectively, which confirm the least interference between output channels. Besides, linear dielectric rods form the filter design that leads to the filter's appropriate performance at a low input power that is the most important benefit of this work compared to other recently published articles. The maximum rise time of the proposed filter for all output ports is less than 8 ps. The structure also has 375.84 µm<sup>2</sup>, which makes the filter easy to use in photonic integrated circuits.

Design of a High-Quality Optical Filter Based on 2D Photonic Crystal Ring Resonator for WDM Systems

Selectable-FSR 10-Ghz Granularity WDM Superchannel Filter in a Reconfigurable Photonic Integrated Circuit

Ring Resonator of Hollow-Core Photonic Crystal Fiber Based on Spatial Coupling Scheme

High Quality Photonic Crystal Waveguide Filters Based on Mode-Gap Effect

Engineering Waveguide-Cavity Resonant Side Coupling in A Dynamically Tunable Ultracompact Photonic Crystal Filter

Design and analysis of a novel four‐channel optical filter using ring resonators and line defects in photonic crystal microstructure

Optical Filter Based on Contra-Directional Waveguide Coupling in A 2d Photonic Crystal with Square Lattice of Dielectric Rods

Optical Filter in Two-Dimension Photonic Crystal Waveguide

Effect of variable dielectric constant of Si material rods on 2-D photonic crystal ring resonator based channel drop filter for ITU.T.694.2 CWDM system

Highly Efficient Oadm Using Mode Gap With Hexagonal Lattice Air-Hole Pc Slab Waveguides

Six Port Waveguide Filter Based On Circular Photonic Crystal

Highly efficient optical filter based on vertically coupled photonic crystal cavity and bus waveguide

Optical Response of High-Order Band Gap in One-Dimensional Photonic Crystal Applying In-Plane Integration

Photonic Crystal Channel Drop Filter with a Wavelength-Selective Reflection Micro-Cavity

Thermally Tunable High-Order Microring Filters with Large Free-Spectral-range

Ultracompact, Reflection-Free and High-Efficiency Channel Drop Filters Based on Photonic Crystal Nanobeam Cavities

Design and Simulation of a Compact Plasmonic Photonic Crystal Fiber Filter with Wide Band and High Extinction Ratio

Dual-band Optical Filter Based on a Single Microring Resonator Embedded with Nanoholes

Design and analysis of two-dimensional photonic crystals channel filter

High Resolution Three-Port Filter In Two Dimensional Photonic Crystal Slabs

Second-Order Microring Filter with Large Free-Spectral-Range and Wavelength-Tunable-Range over 50 Nm