Abstract:Tantalum is used as a diffusion barrier and adhesion promoter layer between the dielectric material and copper interconnects. The present study was intended to investigate the effect of oxidizer and solution pH on chemical mechanical planarization of tantalum. High purity Ta disks were used to study the dissolution and oxidation kinetics under static and dynamic conditions using various solutions in acidic and alkaline pH regimes. The electrochemical measurements during dynamic polishing of a Ta disk were carried out using slurries containing silica and alumina particles with hydrogen peroxide at various pH levels. The affected surface layers of the statically etched Ta disk were investigated using X-ray photoelectron spectroscopy (XPS), atomic force microscopy (AFM), and secondary ion mass spectrometry (SIMS). Ta metal was observed to oxidize in aqueous solutions at pH 2, 4, and 12 in absence of The oxidation process follows the parabolic kinetic law and oxidation rate was observed to be higher in an alkaline region than in an acidic region. In the presence of however, Ta dissolved in the alkaline region. The dissolution was found to be greater at pH 12 mainly because of enhanced dissociation of in alkaline region. At pH 2, on the contrary, mass gain was observed probably due to an increase in content on the top of Ta oxide formed on the surface as confirmed by XPS and SIMS depth profile studies. XPS study revealed that the oxidation of tantalum takes place at a rapid rate and forms soluble oxotantalate and hydroxotantalate in solution at pH 12 in the presence of hydrogen peroxide. AFM study validates both the XPS and the SIMS results, indicating formation of a thin impervious oxide layer on Ta in a solution at pH 2 with 5% and a porous layer was formed on Ta in solution with 5% at pH 12. Consequently, the dissolution rate in alkaline region was enhanced which was confirmed by dynamic removal rate measurements, electrochemistry, and XPS studies. © 2002 The Electrochemical Society. All rights reserved.

On the Anodic Dissolution of Tantalum and Niobium in Hydrofluoric Acid

Study on dissolution mechanism of mineral/liquid interface during HF acid leaching niobium-tantalum ore

Hydrometallurgical Separation of Niobium and Tantalum: A Fundamental Approach

NIOBIUM’S BEHAVIOR IN AQUEOUS HYDROFLUORIC ACID SOLUTION

Selective Reduction of Niobium(V) Species to Promote Molecular Niobium/Tantalum Separation

Extraction and Separation of Tantalum and Niobium by Liquid-Liquid Extraction in the Hydrofluoric Acid-Tributyl Phosphate System

Corrosion behavior of niobium, tantalum and their alloys in hot hydrochloric and phosphoric acid solutions

A Review on the Separation of Niobium and Tantalum by Solvent Extraction

Non-fluoride dissolution of tantalum and niobium oxides and their separation using ion exchange

A fluoride-free liquid-liquid extraction process for the recovery and separation of niobium and tantalum from alkaline leach solutions

Effect of Ph and H[sub 2]o[sub 2] on Ta Chemical Mechanical Planarization

Selective recovery of niobium and tantalum from low-grade concentrates using a simple and fluoride-free process

Separation of niobium and tantalum using continuous multistage counter-current solvent extraction with trioctyl amine

Corrosion Resistance of Nb and NbTi Alloy Predicted by Hydrogen Evolution Reaction Models Modified with Langmuir Isotherm Adsorption Theory

Extraction Recovery of Tantalum(V) and Niobium(V) from Hydrofluoric and Hydrofluoric-Sulfuric Acid Aqueous Solutions with Octanol

Electrochemical Behavior of Tantalum in Anhydrous Ethanol

Electrochemical Behavior of Niobium Oxide and Titanium Oxide in NaF–Na3AlF6 Molten Salt

Tantalum, easy as Pi: understanding differences in metal-imido bonding towards improving Ta/Nb separations