Analysis of the Effects of a Rotating Rock on Rockfall Protection Barriers

Xin Qi,Xiangjun Pei,Rui Han,Yafeng Yang,Qingcheng Meng,Zhixiang Yu

DOI: https://doi.org/10.1007/s10706-018-0535-6

2018-03-31

Geotechnical and Geological Engineering

Abstract:Due to limitations associated with field tests and equipment, the majority of the research conducted to evaluate the mechanical behaviour of rockfall protection barriers considers only free-falling rocks when simulating the actual situation. Based on this fact, this study introduces ψ, the ratio of the rotational kinetic energy to the kinetic energy of a rockfall, to study the rotational effect and to achieve an optimal design. LS-DYNA is used to analyse the dynamic response of the system under the impact of a rolling rock. The results indicate that a rolling rock is an adverse condition. As ψ increases, the rock displacement decreases with a clear outward rolling, which causes greater deformation of the energy dissipater of the upper support rope and greater displacement of the free end of the steel post. As ψ approaches 0.2, the tensile forces of the upper support rope and the anchor rope reach their peak values, which are 39% higher than the corresponding values when ψ is 0. Additionally, the maximum forces of the steel post and net increase by 29 and 20%, respectively. The energy consumption of the break rings and wire ring net decrease linearly. However, the slide energy and friction energy increase linearly. To facilitate further research, correction coefficients that incorporate the effect of a rotational impact and formulas that include a relation between ψ and the force of each component are obtained through curve fitting.