Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Synthesis and Electrochemical Studies of rGO/ZnO Nanocomposite for Supercapacitor Application

Structural, electrochemical and corrosion resistance properties of ZnO/rGO nanocomposite for supercapacitor electrode material

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

ZnO-CuO nanoparticles enameled on reduced graphene nanosheets as electrode materials for supercapacitors applications

Facile synthesis of perovskite ZnMnO3 composite with reduced graphene oxide via solvothermal route for supercapacitor applications

Fabrication of nanoarchitectures for next-generation supercapacitors: interconnected Zn2SnO4 and 2D rGO for enhanced energy storage performance

Facile Synthesis of Well-Dispersed Bi2O3 Nanoparticles and Rgo As Negative Electrode for Supercapacitor

A Facile Microwave Hydrothermal Synthesis of ZnFe2O4/rGO Nanocomposites for Supercapacitor Electrodes

Zinc Cobalt Sulfide/Reduced Graphene Oxide Nanocomposite for High‐Performance Asymmetric Supercapacitor: A Microwave‐Assisted Synthesis

Synergistic Effect of Fe3O4/reduced Graphene Oxide Nanocomposites for Supercapacitors with Good Cycling Life

Rhinestone sheet like carbon and metal oxide‐based nanocomposites for flexible supercapacitor applications

One-Step Microwave-Assisted Hydrothermal Preparation of Zn-ZnO(Nw)-rGO Electrodes for Supercapacitor Applications

Cobalt Sulfide/Reduced Graphene Oxide Nanocomposite with Enhanced Performance for Supercapacitors

Synthesis of BaO/NiO/rGO nanocomposite for supercapacitor application

Synthesis and Characterization of rGO-Anchored MnO2 Nanorods and their Application in Supercapacitors as Electrode Material

Growth of Zinc Cobaltate Nanoparticles and Nanorods on Reduced Graphene Oxide Porous Networks Toward High-Performance Supercapacitor Electrodes

Surface design and engineering of ZnMn2O4/RGO composites for highly stable supercapacitor devices

Study of electrochemical behavior of rGO and Metal-Organic Framework nanocomposite electrodes for supercapacitive applications

Mesoporous Composite Nickel Cobalt Oxide/graphene Oxide Synthesized Via a Template-Assistant Co-Precipitation Route As Electrode Material for Supercapacitors

Graphene/ZnO Hybrid Nanocomposites Electrode Material for High-Performance Supercapacitor Application

Enhanced electrochemical performance of the electrodeposited nickel sulfide on ZIF-67@RGO composite for supercapacitor applications