Pantograph-catenary of High Speed Train Project/General Sci-Tech Report
Yunshuang Ma,Ning Zhou,Ronghua Huan,Qiang Gao,Guoqiang Gao
DOI: https://doi.org/10.3969/j.issn.1674-098X.2016.16.093
2016-01-01
Abstract:Pantograph and catenary system are comprehensively investigated at high speed. Firstly, different models of the catenary are established to determine the wave characteristics for this catenary. Then,the co-simulation method of fluid-structure coupled analysis for pantograph-catenary system is established. The trains passing through the tunnels and the wind-induced vibration of catenary are analyzed. Secondly, by experimental testing on the pantograph bottom damper and the pantograph head suspension system, the nonlinear characteristic curves and the corresponding mathematical models are obtained in the catenary irregularity research. Meanwhile, for numerical simulation of pantograph-catenary coupled system, the accuracy and efficiency are both satisfied if the string element is used for catenary messenger wire and the beam element is used for contact wire. In electrical content aspect, electrical field distribution and its relationship to vibration gap have been studied. Relationship among traction current, vibration gap, stagger and electromagnetic force has been studied. Finally, pantograph-catenary arc and catenary wave characteristics experiment has been conducted for supporting the theoretical research. It is demonstrated that investigating the wave characteristics of the catenary by using the actual catenary model with multiple spans is reasonable, and it is effective to determine the wave characteristics through the simulation of pantograph and catenary coupled system. Due to the effect of tunnel wall confinement, the aerodynamic drag, lift forces of pantograph and uplift displacements of the contact wire are increased. It is important to effectively control the displacements and stresses of catenary induced by the wind loads. On the other hand, catenary irregularity threshold provides reference for catenary installation and maintenance. For simulation of pantograph-catenary coupled system, the accuracy and efficiency are both satisfied if the string element is used for catenary messenger wire and the beam element is used for contact wire. Electromagnetic force is small in normal situation. But it will enlarge rapidly in short circuit and affects dynamic features of pantograph-catenary obviously. Pantograph- catenary arc has large influence on wear rate of carbon slipper and contact surface temperature rise, lead to current distortion of circuit for affecting the electrical equipment adversely.