Abstract:ObjectivesThis paper aims to study the influencing factors and mechanisms of ship model resistance prediction uncertainty, as well as proposing corresponding suppression methods. MethodsResistance tests and local flow measurements on the flow around KCS models of 1.725 m and 3.450 m are carried out in a circulating water channel. The effects of the model scale on the resistance predictions are obtained by comparing the results of the two tests. Numerical simulations of the flow around the 3.450 m model in an unbounded water area and circulating water channel are achieved. The results under the two conditions are compared to analyze the blockage effect and validate the simplified Tamura correction formula. Numerical simulations of the flow around the 3.450 m model under different turbulence intensities in a circulating water channel are then carried out to analyze the effects of turbulence intensities on resistance predictions. ResultsThe results show that the resistance prediction uncertainty of small ship models due to statistics collections and inflow uniformity can be amplified if the inflow velocity is too low. This demonstrates that the blockage effect of the large model could increase hull sinkage, pressure gradients on the hull and wave amplitudes, leading to an increase in ship resistance. The average difference between the resistances predicted in the unbounded water area and circulating water channel is 4.56% without correcting for the blockage effect. The difference is reduced to 2.25% with the correction of the simplified Tamura formula. The total resistance increases by an average of 3.75% as the turbulence intensity increases from 1% to 2%. It is observed that the decay of turbulence intensity along the flow direction is linear from the entrance to the bow. ConclusionsThis study shows that reasonably large models should be used wherever possible and the turbulence intensity should be strictly controlled to reduce the uncertainty of ship resistance tests in circulating water channels. In addition, the simplified Tamura formula should be used to correct the blockage effect, and the appropriate inflow turbulence intensity should be used in numerical prediction according to the dissipation of the turbulence intensity.

Comparison of Selected Parametric Methods for Prediction of Inland Waterways Ship Hull Resistance in Towing Tank Test

Full-scale CFD simulations for the determination of ship resistance as a rational, alternative method to towing tank experiments

Methods of Determination of Frictional Resistance for Prediction of Total Resistance of Inland Waterway Vessels

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Hull Resistance of An Inland Waterway Vessel in Model Scale and in Full Scale

Numerical Estimation of Hull Hydrodynamic Derivatives in Ship Maneuvering Prediction

On the Vessel Energy Requirement Prediction From the Acceleration Stage Towing Experiments on Models

A method for ship resistance prediction based on CFD computation

Predicting practical ship powering and speed loss in waves using added resistance test results

Comparative investigations on hull line optimization based on traditional and fully parametric methods for saving energy

A Study of Hybrid Prediction Method for Ship Parametric Rolling

Unsteady ship–bank interaction: a comparison between experimental and computational predictions

Investigation on practical correction for added resistance prediction of tankers

Assessment of CFD-Based Ship Maneuvering Predictions Using Different Propeller Modeling Methods

Planing Hull Hydrodynamic Performance Prediction Using LincoSim Virtual Towing Tank

Resistance and Strength Analysis of Three Hulls with Different Knuckles

Uncertainty suppression methods for CFD/EFD resistance prediction of ship model

A Study On Applicability Of Cfd Approach For Predicting Ship Parametric Rolling

Comparative Study of Trimaran’s Resistance Optimization by Potential/Viscous-Flow Methods

Comparative Investigation of an Automated Oceanic Wave Surface Glider Robot Influence on Resistance Prediction Using CFD Method