Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Filter Design of Adjusting Common Phase for Vibration Suppression Control of Multi-Degree-of Freedom System

Performance Analysis of High-Static-low-dynamic Stiffness Vibration Isolator with Time-Delayed Displacement Feedback

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Combining Input Shaping and Adaptive Model-Following Control for Vibration Suppression

Design of an Active Vibration Isolation Control Strategy Based on IFT Method

Active Control for Non-Autonomous Diaphragm-Type Pneumatic Isolation System by Using an Augmented Adaptive Sliding-Mode Controller

Active Damping Control of the Large-scale Flexible Hydraulic Manipulators with Independent Metering System

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Multi-frequency Compensation for Active Magnetic Bearing-Flexible Rotor System Based on Adaptive Least Mean Square Algorithm with a Phase Shift

Resonant suppression of flexible system using band-stop filter

Active Damping Control of the Large-scaleFlexible Hydraulic Manipulators Withindependent Metering System

Stability Analysis and Design of n-DOF Vibration Systems Containing Both Semi-Active and Passive Mechanical Controllers

Resonant Suppression of Flexible System by Feedback Compensation of Resonant Frequencies

Basic Study on Mechanical Vibration Suppression System Using 2-Degree-of-Freedom Vibration Analysis

An Active Vibration Isolation Control Method under Excitation of Multi-Line Spectra

Reference input design of dual-mode vibration suppression control for 2DOF horizontal robot arm

Vibration suppression of a beam using variable structure control with disturbance observer

Optimal Actuator Placement and Active Vibration Control of Over-Actuated Motion System in the Wafer Stage

Active Vibration Control of a High-Speed Flexible Robot Using Variable Structure Control

Multi-objective optimal design of active vibration absorber with delayed feedback

A Novel Piecewise Frequency Control Strategy Based on Fractional-Order Filter for Coordinating Vibration Isolation and Positioning of Supporting System