Abstract:Latent heat storage in district cooling systems (DCS) offers advantages such as energy efficiency, load shifting, and flexibility. It optimizes energy utilization by storing thermal energy during off-peak hours and using it during peak periods. This results in cost savings, a reduced environmental impact, and the enhanced reliability of the cooling system. In the present study, a novel system consisting of a phase-change material (PCM) tank coupled to a 120 kW chiller generator for cooling is proposed. During peak cooling loads, the proposed PCM tank is intended to supply consistent thermal power at an appropriate temperature. The system is modeled using the lumped-capacitance approach, and the effective thermal capacity approach is used to model the PCM's phase-transition phenomena. The system's dynamic performance is evaluated, and the impact of various parameters during the PCM-tank discharging process is analyzed. The computational findings are compared to experimental data taken from a real district network, and there is excellent agreement. Results showed that increasing the needed heat rate for the cooling process from 120 kW to 160 kW decreases the PCM tank's discharging duration by about 20% and increases pump energy consumption. It was also found that increasing the capacity of the PCM tank is advantageous for the cooling process as it extends the duration of 120 kW constant power production by about 62% when the tank volume is increased from 5 m3 to 10 m3. Finally, it was shown that the choice of the PCM type is crucial for improving the cooling performance. Erythritol is a suitable storage medium in the tank compared to A118 and MgCl2·6H2O, and using erythritol instead of PCM A118 increases the period of continuous thermal power generation by about 67%.

Active Phase Change Material Cold Storage in Off-Grid Telecommunication Base Stations: Potential Assessment of Primary Energy Savings

STUDY ON CHARGING AND DISCHARGING RATES OF LATENT HEAT THERMAL ENERGY STORAGE SYSTEMS EMPLOYING MULTIPLE PHASE CHANGE MATERIALS

Performance Study of Phase Change Charging/discharging Processes of Condensing Heat Storage in Cold Regions Based on a Mathematical Model

System Performance and Economic Analysis of a Phase Change Material Based Cold Energy Storage Container for Cold Chain Transportation

Novel scheme for a PCM-based cold energy storage system. Design, modelling, and simulation

Enhancing energy efficiency of air conditioning system through optimization of PCM-based cold energy storage tank: A data center case study

Optimal Phase Change Temperature for Energy Storage Based on Fluctuating Loads in Building Cooling Heating and Power System

Modeling and Dynamic Simulation of a Phase-Change Material Tank for Powering Chiller Generators in District Cooling Networks

Energy saving opportunities in the refrigerated transport sector through Phase Change Materials (PCMs) application

Simulation of Cooling a Telecommunication Base Station Using Ambient Energy

Energy Performance Analysis on Telecommunication Base Station

The use of phase change materials in domestic heat pump and air-conditioning systems for short term storage: A review

An Economic Analysis of Energy Saving and Carbon Mitigation by the Use of Phase Change Materials for Cool Energy Storage for an Air Conditioning System—A Case Study

Using Renewables Coupled with Thermal Energy Storage to Reduce Natural Gas Consumption in Higher Temperature Commercial/industrial Applications

Simulation On Energy Performance Of Air-Conditioning System Assisted With Thermosyphon Used In Telecommunication Base Station

Using Thermal Energy Storage to Replace Natural Gas in Commercial/Industrial Applications

Phase change material thermal energy storage systems for cooling applications in buildings: A review

Phase Change Materials (PCM) for a Zero-carbon Food Preservation Technology in Remote Areas

Efficient simulation strategy for PCM-based cold-energy storage systems

Research Progress on the Phase Change Materials for Cold Thermal Energy Storage

Thermal Management of Standby Battery for Outdoor Base Station Based on the Semiconductor Thermoelectric Device and Phase Change Materials