AUTHOR'S METHOD FOR DETERMINING THE BEARING CAPACITY OF INCLINED SECTIONS OF BEAM STRUCTURES UNDER REPEATED LOADS
Yu.A. Somina,V.M. Karpiuk,A.I. Kostiuk,,,
DOI: https://doi.org/10.31650/2415-377x-2022-86-69-77
2022-03-31
Bulletin of Odessa State Academy of Civil Engineering and Architecture
Abstract:Analysis of the results of both our own tests and studies of other scientists shows that the destruction of structures under the action of repeated loading occurs at lower stresses than the destruction of structures under the action of short-term static loads. Namely, the bearing capacity of beams under the action of cyclic loads is on average 10% lower compared to the bearing capacity of their "twins" under static forces, that must be taken into account when calculating and designing structures. In this regard, the author's method for calculating inclined sections of reinforced concrete beam structures under low-cycle and multi-cycle loads is presented in the paper. Repeated loads are proposed to be taken into account by calculating the fatigue strengths of the beam’s materials, namely the compressed zone of concrete above the critical inclined crack, the longitudinal reinforcement at the intersection with the inclined crack, as well as the anchoring of the longitudinal reinforcement. In particular, the design lines of endurance of concrete and reinforcement are considered. In practical calculations, the change in stresses that occurs due to the development of vibrocreep deformations of compressed concrete at complex stress state is taken into account by the functions of stress accumulation in concrete, longitudinal and transverse reinforcement. These functions of deformations of concrete vibrocreep are calculated according to the theory of vibrocreep. According to the results of the research, the corresponding author's expressions and dependencies are derived and presented, which allow determining the limit forces of structural element with a given shear span. In addition, it is proposed to introduce the coefficient kcyc into the calculation, which takes into account the more destructive effect of a multi-cycle load compared to a low-cycle repeated one. Thus, kcyc is the ratio of the breaking shear force to the minimum design ultimate endurance force of the near support sections of the specimens-beams, calculated using the characteristic values of the strength of concrete and reinforcement, that is, the prismatic strength of concrete and the yield strength of reinforcement.