Abstract:It is a great challenge to improve the process stability in conventional underwater wet welding due to the formation of unstable bubble. In this study, mechanical constraint method was employed to interfere the bubble generated by underwater wet welding, and the new method was named as mechanical constraint assisted underwater wet welding. The aim of the study was to quantify the combined effect of wire feed speed and condition of mechanical constraint on the process stability in mechanical constraint assisted underwater wet welding. Experimental results demonstrated that the introduction of mechanical constraint not only suppressed the bubble without floating but also stabilized the arc burning process. The degree of influence of mechanical constraint, which changed with wire feed speed, played an important role during the mechanical constraint assisted underwater wet welding process. For all wire feed speeds, the fluctuations of welding electrical signal were decreased through introduction of mechanical constraint. The difference in the proportion of arc extinction process between underwater wet welding and mechanical constraint assisted underwater wet welding became less with increasing wire feed speed. At wire feed speed lower than 7.5 m/min, the improvement of process stability was very significant by mechanical constraint. However, the further improvement produced limited effect when the wire feed speed was greater than 7.5 m/min. The observation results showed that a better weld appearance was afforded at a large wire feed speed, corresponding to a lower variation coefficient.

Influence of calcium fluoride on underwater wet welding process stability

Influence of CaF2 on Microstructural Characteristics and Mechanical Properties of 304 Stainless Steel Underwater Wet Welding Using Flux-Cored Wire

Study of underwater wet welding stability using an X-ray transmission method

Effect of metal transfer mode on spatter and arc stability in underwater flux-cored wire wet welding

Effect of Water Flow on the Arc Stability and Metal Transfer in Underwater Flux-Cored Wet Welding

Effect of Filling Rate on Underwater Wet Welding Process and Weld Appearance

The Effect of Alumino-Thermic Addition on Underwater Wet Welding Process Stability

Metal transfer in underwater flux-cored wire wet welding at shallow water depth

Variation of Surface Tension of Liquid Metal with Fluorides in Tungsten Inert Gas Welding

Effect of Boric Acid on Metal Transfer Mode of Underwater Flux-Cored Wire Wet Welding

Correlation between wire feed speed and external mechanical constraint for enhanced process stability in underwater wet flux-cored arc welding

Investigation on the mass transfer control, process stability and welding quality during underwater pulse current FCAW for Q235

Investigating the Advantages of Ultrasonic-assisted Welding Technique Applied in Underwater Wet Welding by In-Situ X-ray Imaging Method

Study of metal transfer control in underwater wet FCAW using pulsed wire feed method

Effect of Parameters Change on the Weld Appearance in Stainless Steel Underwater Wet Welding with Flux-Cored Wire

Effect of hydrostatic pressure on protective bubble characteristic and weld quality in underwater flux-cored wire wet welding

Control Of Droplet Transition In Underwater Welding Using Pulsating Wire Feeding

Effect of water depth on weld quality and welding process in underwater fiber laser welding

Comparative Evaluation of Self-Shielded Flux-Cored Wires Designed for High Strength Low Alloy Steel in Underwater Wet Welding: Arc Stability, Slag Characteristics, and Joints’ Quality

Classification of Metal Transfer Mode in Underwater Wet Welding

Effects of processing parameters on arc stability and cutting quality in underwater wet flux-cored arc cutting at shallow water