Supercritical Carbon Dioxide Extraction of Astaxanthin, Lutein, and Fatty Acids from Haematococcus pluvialis Microalgae

Giuseppe Di Sanzo,Sanjeet Mehariya,Maria Martino,Vincenzo Larocca,Patrizia Casella,Simeone Chianese,Dino Musmarra,Roberto Balducchi,Antonio Molino,Giuseppe Sanzo

DOI: https://doi.org/10.3390/md16090334

2018-09-13

Marine Drugs

Abstract:Haematococcus pluvialis microalgae in the red phase can produce significant amounts of astaxanthin, lutein, and fatty acids (FAs), which are valuable antioxidants in nutraceutics and cosmetics. Extraction of astaxanthin, lutein, and FAs from disrupted biomass of the H. pluvialis red phase using carbon dioxide (CO2) in supercritical fluid extraction (SFE) conditions was investigated using a bench-scale reactor in a semi-batch configuration. In particular, the effect of extraction time (20, 40, 60, 80, and 120 min), CO2 flow rate (3.62 and 14.48 g/min) temperature (50, 65, and 80 °C), and pressure (100, 400, and 550 bar.) was explored. The results show the maximum recovery of astaxanthin and lutein achieved were 98.6% and 52.3%, respectively, at 50 °C and 550 bars, while the maximum recovery of FAs attained was 93.2% at 65 °C and 550 bars.

pharmacology & pharmacy,chemistry, medicinal

What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to efficiently extract astaxanthin, lutein and fatty acids (FAs) from Haematococcus pluvialis. These compounds have important antioxidant and anti - aging properties and are widely used in the fields of nutraceuticals, cosmetics, etc. However, because the cell wall of Haematococcus pluvialis is very tough, it is difficult for traditional extraction methods to extract these high - value - added compounds efficiently and environmentally friendly.

To solve this problem, the author used the Supercritical Fluid Extraction using CO₂ (SFE - CO₂) technology to study the effects of different operating conditions (such as temperature, pressure, CO₂ flow rate and extraction time) on the extraction efficiency of astaxanthin, lutein and fatty acids. Specifically, the author optimized the extraction conditions in the following ways:

1. **Mechanical pretreatment**: Use the ball - milling method to break the cell wall of Haematococcus pluvialis to promote the release of target compounds.
2. **SFE - CO₂ parameter optimization**: Systematically studied the effects of CO₂ flow rate (3.62 g/min and 14.48 g/min), extraction time (20 - 120 minutes), temperature (50 - 80°C) and pressure (100 - 550 bar) on the extraction effect.

Finally, the author found that:
- At a temperature of 50°C and a pressure of 550 bar, the maximum recovery rate of astaxanthin was 98.6%.
- The maximum recovery rate of lutein was 52.3%, also at a temperature of 50°C and a pressure of 550 bar.
- The maximum recovery rate of fatty acids was 93.2% at a temperature of 65°C and a pressure of 550 bar.

These results indicate that by optimizing the operating conditions of SFE - CO₂, efficient and environmentally - friendly extraction of astaxanthin, lutein and fatty acids can be achieved.