Abstract:The current method of dynamic rail profile measurement involves the installation of a line-structured light sensor at the base of the train. The accuracy of this measurement is influenced by the vertical relationship between the laser plane of the light sensor and the longitudinal direction of the rail (LDR). When a train travels in a straight line, the normal of the laser plane aligns with the LDR. However, when the train curves, the angle at which its wheels connect with the rails causes the laser plane's normal direction to deviate from the LDR, leading to measurement errors. To address this issue, we propose a method for curved rail profile measurement using a dual-beam laser to correct these errors. This method involves generating an auxiliary 3D rail reflecting the LDR and a virtual 3D rail reflecting the normal direction of the laser plane from the cross-section image of the dual-beam laser. An optimization function is then formulated to determine the optimal auxiliary plane (optimal-AP) by analyzing the alignment or intersection between the auxiliary and virtual 3D rails. Distorted contour points are projected onto the optimal-AP to rectify errors. Experiments validate the accuracy and effectiveness of this proposed method. The results show that, regardless of pitch or yaw movement between the laser plane and the LDR, the error in measuring corrected profile wear remains consistently below 0.10 millimeters, thereby meeting the accuracy standard for rail wear measurement. This approach rectifies measurement errors in curved rail profiles from a 3D perspective, ensuring accurate measurements even under complex working conditions. It also provides a valuable reference for error analysis and improving dynamic rail profile measurement accuracy.

Research on Straightness Detection Device for Elevator Guide Rail

Full-automatic detector for straightness of elevator guide rail

Modeling, simulation and experiment for straightening lateral bending of elevator guide rail

Automated Detecting System for Elevator Guide Rails Based on Tilt Sensors and Acceleration Sensors

Key technologies of vertical press-straightening of elevator rail

Residual Stress Distributions in Elevator Guide Rail Straightening

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Vision-Based Position Deviation Measurement of Rail Corrugation Chord Measuring Points under Bi-Linear Laser Assistance

A Systemic Model for Simultaneously Measuring Three dimensional Rotation Angles of the Linear Guide Track [J]

Straightness Detection Method and Accuracy Analysis of Guide Rail Parts

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Vibration Analysis of High-speed Traction Elevator Based on Guide Roller-rail Contact Model

Rail straightness detection method based on the cooperation of dual laser sensors

Wavelet Denoising of the Horizontal Vibration Signal for Identification of the Guide Rail Irregularity in Elevator

Research on 3-Point Relaying Method Used in Dynamic Measurement of Straightness for Large Workpiece

Research on Dynamic Detection of Geometric Parameters of Groove Rail Based on Laser Triangulation and Four-Point Chord Measurement

Research Progress on Detection Technology of Composite Electrical Traction Steel Strip for Elevator

A Straightening Control System for the Linear Guide Rail

Error correction method based on dual-beam laser for curved rail profile measurement

Research on Inspection Method on Site and Hydraulic Systems for Hydraulic Elevator

Research on the rail waist defect testing with laser-EMAT ultrasonic and signal processing