Abstract:An extensive experimental study is presented including around 140 triaxial compressive strength tests on artificially jointed hard rock. The experiments were performed on cylindrical and jointed specimens with either 1 sub-vertical and 2 sub-horizontal (1 + 2) or 2 sub-vertical and 3-sub-horizontal (2 + 3) joint sets. The specimen diameter consisted of 38, 54 and 84 mm and the rock was Blanco Mera granite. The confining pressures ranged between 0.2 and 15 MPa and such a testing program complements the previous study in this regard with about 100 triaxial tests on intact rock specimens. A complete set of stress-strain curves were obtained from the experiments followed by extracting the peak and residual strengths as well as indicative deformability parameters (elastic and Poisson's ratio). For the jointed specimens, the indirect strain measurement was corrected to implicitly calculate the elastic parameters following the energy-based concept. It was found that the peak strength is joint set dependent as per the conventional rock mass classification systems. For jointed specimens a moderate strength size effect was observed in which the peak strength tended to increase with size from 38 mm to 54 mm and then decreased with a rise in specimen diameter. Also, it was concluded that the effect of size on peak strength become less prominent in cases with more joints and the influence of additional jointing becomes less significant for larger specimens; both are novel findings which have not been explored before. The approximated variable elastic parameters of jointed specimens exhibited size independency but joint and confinement dependency, while the variable Poisson's ratios specifically, appeared to be size and joint set independent. The presented stress-strain data from granite specimens suggests that the mechanical parameters of jointed rock are largely controlled by the rock structure where the specimen size can play a significant role, particularly at low confinements.

Influence of specimen size and shape on the uniaxial compressive strength values of selected Western Carpathians rocks

New Statistical Quantification Method for the Size Effect Behavior of Rock Mass Using Compressive Strength As an Example

Study Of Shear Strength Characteristics Of Simulation Rock Structural Planes Based On Multi-Size Direct Shear Tests

An experimental study of size effect of roughness coefficient on rock joint using push-pull apparatus

Loading rate conditions and specimen size effect on strength and deformability of rock materials under uniaxial compression

Size-Dependent Behaviour of Hard Rock Under Triaxial Loading

Experimental Study of Size Effects on the Deformation Strength and Failure Characteristics of Hard Rocks under True Triaxial Compression

A review of test methods for uniaxial compressive strength of rocks: Theory, apparatus and data processing

Effect of Specimens’ Height to Diameter Ratio on Unconfined Compressive Strength of Cohesive Soil

Specimen Size and Shape Effect on the Compressive Strength of Normal Strength Concrete

Size effects on strength and deformability of artificially jointed hard rock

Effects of specimen size on linear energy storage and dissipation laws of red sandstone under uniaxial compression

Analysis of size effect and its influencing factors of brittle red sandstone with different heights

Reliability of Monte Carlo simulation approach for estimating uniaxial compressive strength of intact rock

Prediction of uniaxial compressive strength of carbonate rocks from nondestructive tests using multivariate regression and LS-SVM methods

Assessment of Direct Tensile Strength Tests in Rock Through a Multi-laboratory Benchmark Experiment

Numerical simulation and interpretation of the grain size effect on rock strength

Evaluation of different surface characteristics and mineral grain size in the estimation of rock strength using the Schmidt hammer

Machine learning methods for predicting the uniaxial compressive strength of the rocks: a comparative study

Accuracy of Point Load Index and Brazilian Tensile Strength in Predicting the Uniaxial Compressive Strength of the Rocks: A Comparative Study

Development of empirical equations between uniaxial compressive strength and point load index: a case study for sandy dolomite