Abstract:The present study aimed at investigating the microstructure evolution mechanism and mechanical properties of the rare earth magnesium alloy (Mg-RE alloy). The compression tests over a temperature range of 250-450 °C as well as the interrupted compression tests at a temperature of 350 °C and a strain rate of 0.1 s−1 to strains of 0.02, 0.39, 0.79 and 1.48 were conducted by using Gleeble-3800. The results show that there exists a critical transition temperature of material performance. When the temperature is lower than 350 °C, the fracture occurs at the strain of 0.31 and there was poor toughness; on the contrary, when the temperature is higher than 350 °C, there is no crack even if the strain is up to 1.49. At the same time, the material exhibited pseudo-super plastic behavior. Furtherly, the microstructure tends to be uniform and fine grains exist around some large and long grains. And, many particles emerge in the grains and at the grain boundaries. These results imply that dynamic recrystallization occurs in advance during deformation. It is found that the second-phase particles play an important role in particle stimulated nucleation effect and promote dynamic recrystallization. With further increasing strain, θ becomes negative and then tends to zero. This is because that the work hardening and strain softening compete with each other and finally reach a dynamic equilibrium. Moreover, fine grains were formed at the particles, which provided a potential path for localized shear zones. During hot deformation process, the continuous dynamic recrystallization mechanism and grain boundary strengthening were dominated. The grain growth and the particles appearance became the primary mechanism of microstructure evolution. Besides, the optimal initial reduction of 32.3% is determined. These results can help guide the development of feasible processes to enhance strength and ductility.

Atomic Scale Investigation on Precipitates and Defects of Mg–RE Alloys: A Review

Thermodynamics and kinetics of phase transformation in rare earth–magnesium alloys: A critical review

Study on the strengthening mechanism of rare earth yttrium on magnesium alloys

Physical factors controlling the observed high-strength precipitate morphology in Mg–rare earth alloys

Research Progress on Microstructure and Mechanical Properties of Medical Rare-Earth Magnesium Alloys

Towards developing Mg alloys with simultaneously improved strength and corrosion resistance via RE alloying

Recent advances on grain refinement of magnesium rare-earth alloys during the whole casting processes: A review

Recent advances of high strength Mg-RE alloys: Alloy development, forming and application

The main strengthening phases transformation and their strengthening mechanisms in as-cast Mg-Gd-(Y)-Zn alloys: A review

Kinetic Simulation of Early-Stage Precipitation Behavior in Mg-RE Binary Alloys During Aging Process

Effect and Application of Rare Earth Element in Magnesium Alloys

Structure And Mechanical Properties Of Mg-Zn-Re System Alloys

Study on the Strengthening Mechanism of Rare Earth Ce in Magnesium Alloys, Based on First-Principle Calculations and Electronegativity Theory

Microstructure Evolution Mechanism and Mechanical Properties of Mg-RE Alloy at a Critical Transition Temperature of Material Performance

Effect of twin assisted precipitation on the microstructure and mechanical properties of gradient structure Mg-Gd-Zn-Zr alloy

Early stages of precipitation and microstructure control in Mg–rare earth alloys

Mechanism of high-strength and ductility of Mg-RE alloy fabricated by low-temperature extrusion and aging treatment

Investigation and Application of Excellent Performance Mg Rare Earth Alloys As a Structural Material

Effect of Rare Earths on Hot Cracking Resistant Property of Mg-Al Alloys

Influence of Rare Earth Elements in Magnesium Alloy - A Mini Review

Effect of Rare-Earth Additions on the Texture of Wrought Magnesium Alloys: The Role of Grain Boundary Segregation