A methodology for setting the injection moulding process parameters for polymer rapid tooling inserts

Anurag Bagalkot,Dirk Pons,Don Clucas,Digby Symons

DOI: https://doi.org/10.1108/rpj-10-2017-0217

2019-10-14

Rapid Prototyping Journal

Abstract:Purpose Polymer rapid tooling (PRT) inserts can be used as injection moulding (IM) cavities for prototyping and low volume production but lack the robustness of metal inserts. Metal inserts can withstand high injection pressure and temperature required, whereas PRT inserts may fail under similar parameters. The current method of parameter setting starts with using the highest pressure setting on the machine and then fine-tuning to optimize the process parameters. This method needs modification, as high injection pressures and temperatures can damage the PRT inserts. There is a need for a methodical process to determine the upper limits of moulding parameters that can be used without damaging the PRT inserts. Design/methodology/approach A case study analysis was performed to investigate the causes of failure in a PRT insert. From this, a candidate set-up process was developed to avoid start-up failure and possibly prolong tool life. This was then tested on a second mould, which successfully avoided start-up failure and moulded 54 parts before becoming unusable due to safety issues. Findings Process parameters that are critical for tool life are identified as mould temperature, injection pressure, injection speed, hold pressure and cooling time. Originality/value This paper presents a novel method for setting IM process parameters for PRT inserts. This has the potential to prevent failure at start up when using PRT inserts and possibly extend the operating life of the PRT inserts.

engineering, mechanical,materials science, multidisciplinary