Abstract:Fuel injection is one of the most important processes in compression-ignition internal combustion engines owing to its significant impact on the exhaust emissions and thermal efficiency. In this study, experiments were carried out to investigate the influence of injection pressure and injection timing on the temporal evolution of the injection rate and injection duration in a specially designed experiment rig equipped with a common rail injection system. It is well known that the injection signal from the electronic control unit (ECU) of the injection system, which is often the only injection information available in engine operation and experiments, gives little information about the actual injection rate profile. It is shown in the present experiments that the actual injection duration is usually longer than the energizing time (ET). The time delay between the actual injection of the fuel and the ECU signal is about 0.3-0.4 ms, and the time delay appears to be insensitive to the injector geometry and injection pressure condition. The injection process can be characterized as five stages, a fast injector valve opening stage, a slow valve opening stage, a valve fully open stage, followed by a slow valve closing stage, and finally a rapid valve closing stage. It is found that the first stage, the fast valve opening stage, is insensitive to the injection pressure and injector nozzle diameter; however, the peak injection rate is a strong function of these parameters. The second and the third stage may not appear with a short injection duration. A new injection model was developed for the common rail injection system, which was capable of simulating the instantaneous fuel injection rate and injection duration for a range of injection pressure and injection duration. The model was shown to be able to replicate the experimental injection rate profile of the present experiments and experiments found in the literature for common rail injection system. The new injection model was applied to predict the effect of injection pressure and injection duration on the performance of a diesel engine under various engine speed and load conditions. The new injection model was shown to be able to describe the injection mass flow rate, which eventually leads to a reasonably good prediction of the variations of the spray development, in-cylinder pressure, heat release rate, and emissions.

Experimental investigation of dwell time characteristics in high-pressure double-solenoid-valve fuel injection system

Dynamic Characteristics of the Nozzle Opening Pressure Based on the Fluid–structure Interaction for a Double-Solenoid-valve Fuel Injection System

An Experimental Study on the Characteristics of Fuel Injection System with Dual High-pressure Actuator Control

Study of Time Gap between Pilot and Main Injections of GD-1 Electronically Controlled Diesel Engine

Characteristics Analysis of Double Valves Fuel System with High Pressure

Effects of Solenoid Valve Drive Current on Fuel Injection Characteristics

Experimental and Numerical Study on the Effects of the Solenoid Valve Motion on the Fuel Pressure Fluctuations for Electronic Unit Pump Systems of Diesel Engines

Study of the injection control valve in a new electronic diesel fuel system

Experimental and Modeling Study of Liquid Fuel Injection and Combustion in Diesel Engines with a Common Rail Injection System

Experimental analysis on the characteristics of two-actuator controlled fuel injection system

Research on Simulation of Electronically Controlled Unit Pump Injection Characteristics

Numerical examination of high-pressure fuel injection in common rail injector based on hydro-mechanical model

Experimental Study on Low Speed Fuel Delivery Characteristics of Electronic Unit Pump Fuel System

Injection control algorithm for an electronic unit-pump

Investigation of the unsteady-flow characteristics in the control valve of a diesel engine unit pump fuel system

Effect of Injection Dynamic Behavior on Fuel Spray Penetration of Common-Rail Injector

Characteristics of Pressure Wave in Common Rail Fuel Injection System of High-Speed Direct Injection Diesel Engines

Investigation of Main Injection Quantity Fluctuation Due to Pilot Injection in High Pressure Common Rail Fuel Injection System

Experimental study on the two-phase fuel transient injection characteristics of the high-pressure natural gas and diesel co-direct injection engine

Dynamic Flow Behavior During Fuel-Offloaded Process in Control Valve for Unit Pump Fuel System

Experimental Study on Injection Process of Electronically Controlled Common-rail Diesel Injection System