Abstract:Syngas fermentation is one of the bets for the future sustainable bio‐based economy due to its potential as intermediate step in the conversion of waste carbon to ethanol fuel and other chemicals. Integrated with gasification and suitable downstream processing, it may constitute an efficient and competitive route for the valorization of various waste materials, especially if systems engineering principles are employed targeting process optimization. In this study, a dynamic multi‐response model is presented for syngas fermentation with acetogenic bacteria in a continuous stirred tank reactor, accounting for gas‐liquid mass transfer, substrate (CO, H2) uptake, biomass growth and death, acetic acid re‐assimilation and product selectivity. The unknown parameters were estimated from literature data using the Maximum Likelihood Principle with a multi‐response nonlinear modeling framework and meta‐heuristic optimization; and model adequacy was verified with statistical analysis via generation of confidence intervals as well as parameter significance tests. The model was then used to study the effects of process conditions (gas composition, dilution rate, gas flow rates and cell recycle) as well as the sensitivity of kinetic parameters, and multi‐objective genetic algorithm was used to maximize ethanol productivity and CO conversion. It was observed that these two objectives were clearly conflicting when CO‐rich gas was used, but increasing the content of H2 favored higher productivities while maintaining 100% CO conversion. The maximum productivity predicted with full conversion was 2 g.L‐1.h‐1 with a feed gas composition of 54% CO and 46% H2 and a dilution rate of 0.06 h‐1 with roughly 90% of cell recycle.This article is protected by copyright. All rights reserved.

Model-Based Stabilization of a Fermentation Process Using Output Feedback with Discrete Time Delay

Dynamic Power Shaping Control of A Continuous Fermentation Process

Examining a Pretty Simple and Low Cost Method for Modeling of Biogas Production from Biodegradable Solids

Dynamic Matrix Control of a Bubble-Column Reactor for Microbial Synthesis Gas Fermentation

Fractional Lotka-Volterra model with time-delay and delayed controller for a bioreactor

Stability of Integral Delay Equations and Stabilization of Age-Structured Models

Mathematical Modeling of a Biotechnological Continuous Fermentation Process for Lactic Acid Production: A Review

Global Stabilizing Control of a Continuous Ethanol Fermentation Process Starting from Batch Mode Production

Stability and bifurcations in a model of chemostat with two inter‐connected inhibitions and a negative feedback loop

Dynamical Output Feedback Stabilization for Neutral Systems with Mixed Delays

Model-Based Adaptive Control of Bioreactors—A Brief Review

Dynamic Behavior Adjustment Of 1, 3-Propanediol Fermentation Process

Hybrid Control of a Bioreactor with Quantized Measurements: Extended Version

ADM1-Based Modeling of Biohydrogen Production through Anaerobic Co-Digestion of Agro-Industrial Wastes in a Continuous-Flow Stirred-Tank Reactor System

Monitoring management criterion of an anaerobic digester using an explicit model based on temperature and pH

Case specific: Addressing co-digestion of wastewater sludge, cheese whey and cow manure: Kinetic modeling

Output Dynamical Feedback Stabilization for Linear Systems with Distributed Delay Based on LMI

Exponential Stabilization for a Class of Strict-Feedback Nonlinear Time Delay Systems via State Feedback Control Scheme

Dynamic modeling of syngas fermentation in a continuous stirred‐tank reactor: Multi‐response parameter estimation and process optimization

Feedback Stabilization for the Mass Balance Equations of an Extrusion Process

Modelling and Economic Optimal Control for a Laboratory-scale Continuous Stirred Tank Reactor for Single-cell Protein Production