Abstract:Several approaches have been proposed over the years that may be used to predict the performance of industrial rod mills. Unfortunately, studies that allow comparing the accuracy in their predictions are very scarce. The work compares four methods for predicting size reduction in an industrial rod mill. These were the Bond work index method (BW) and the Callcott–Lynch (CL) model, both originally proposed for rod mills, besides the Herbst–Fuerstenau (HF) and the Austin–Klimpel–Luckie (AKL) models, first proposed for ball mills, but here adapted and applied to rod milling. A total of 10 industrial surveys were conducted of the industrial mill in dry grinding of coke breeze, covering operation under a variety of conditions, all of which at lower fillings than commonly used in industry (<15%). Since most conditions surveyed were not within the typical operating range for rod mills, simulations using the Discrete Element Method were used to predict the mill power, used as input in both BW and HF models. At first, the fidelity of methods that allow predicting full-scale mill performance solely from bench-scale information, namely BW, HF, and AKL, is compared. Results showed that they all presented high biases in their estimates of product fineness, with AKL predicting finer products whereas BW and HF predicting coarser products. Using then data from a single industrial survey for model calibration (base case), in addition to the bench-scale test results, a comparison of the four approaches became possible. Taking the absolute deviations between measured and predicted P 80 values, it became evident that the HF provided the highest fidelity in the predictions, with mean deviations of 12.8%, AKL with 15.3%, with both BW and CL presenting deviations above 18%. The work thus shows that size-mass balance models that rely on fitting most model parameters from bench-scale tests (HF and AKL) can provide predictions with good confidence when data from an industrial base case are additionally used in fine-tuning the model, even when applied to describing rod milling under unusually low fillings.

Power–gap relationships in low consistency refining

Power Transfer Performance And Cutting Force Effects Of Contactless Energy Transfer System For Rotary Ultrasonic Grinding

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Refining intensity and dynamics of low consistency pulp refining utilizing straight bar plates with dams

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Two sides of a fault: Grain-scale analysis of pore pressure control on fault slip

Relation Between Force Chain Quantitative Characteristics and Side Wall Friction Behaviour During Ferrous Powder Compaction

Specific Energy Dissipation Rate for Super-High-Rate Anaerobic Bioreactor

Effect of the Gap Matching Relation on the Pressure Pulsation Characteristics at Blade’s Surface of the Multiphase Pump

Numerical Investigation of Influence of Rotor-Rotor Gap on Performances of Contra-Rotating Axial Flow Pump

Correlation Mechanism Between Force Chains and Friction Mechanism During Powder Compaction

Modeling the microscale contact status in chemical mechanical polishing process

A method for determining efficiency parameters based on efficiency-quality graph in incremental sheet forming

Modeling of Specific Energy in the Gear Honing Process

Potentials of Vitrified and Elastic Bonded Fine Grinding Worms in Continuous Generating Gear Grinding

Compressions of Electrorheological Fluids under Different Initial Gap Distances

Model modification and influence of edge effect on effective area of giant electro-rheological polishing using plate electrodes

High-fidelity simulation of pebble beds: Toward an improved understanding of the wall channeling effect

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

Comparison of Approaches to Predict Grinding in An Industrial Rod Mill Operating at Low Fillings

Dynamic magnetic field magnetorheological finishing with constant load and variable gap