Abstract:When the grain size is below a critical value, the deformation mechanism of nanocrystalline (NC) metal shifts from dislocation- to grain boundaries (GBs)-mediated activities. However, GB activities including deformation and rotation in the elastic and plastic stages have not given detailed analysis because of the limitation of current experimental techniques, as well as the unrealistic model with regular boundaries in most molecular dynamics (MD) simulation reducing the activities. To quantitatively analyze GB activities, we recently developed an algorithm based on moving least-squares interpolant. Besides, the phase field model was used to build the nanocrystalline (NC) Cu with more natural GBs for MD tensile simulation. The results of temperature dependence of Young's modulus (E), strain rate sensitivity (SRS), and variation of stress at GBs (σGB) and at grain interiors (σGI) are in good agreement with previous researches. In the elastic stage, the σGB fluctuates in a larger range than σGI. The vibrated σGB is the results of micro-elastic and micro-plastic deformation of GBs and the increased stage of σGB in one cycle can lead to increasing the σGI. Thus, the temperature dependence of E is affected by the frequency of vibrated σGB at relative low temperatures (T ≤ 450 K). The E is strain rate independent because of the same vibration of σGB. In the plastic stage, the flow stress strongly depends on the size of twinning boundaries (TBs) structures. The fraction of GB activities improves with increasing temperature and decreasing strain rate. GB activities can attenuate stress concentration on boundaries and then results in the formation and growth mechanism of TB changing from Shockley partial dislocation gliding on adjacent plane of stacking faults (SFs) to GB deformation. Thus, the size of TB at low temperatures and high strain rate is larger than that at the opposite conditions.

The role of low angle grain boundary in deformation of titanium and its size effect

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

In Situ Atomistic Observation of Grain Boundary Migration Subjected to Defect Interaction

Size-Dependent Dislocation-Twin Interactions

Coordinated grain boundary deformation governed nanograin annihilation in shear cycling

Effects of the morphology of grain boundary α-phase on the anisotropic deformation behaviors of additive manufactured Ti–6Al–4V

In situ TEM observations of thickness effect on grain growth in pure titanium thin films

In-situ TEM investigation on deformation mechanisms of a fine-grained 316L stainless steel

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

Exploring the evolutionary behavior of grain boundaries in Titanium induced by temperature fluctuations using a combination of molecular dynamics simulations and experiments

In SituObservation of Dislocation Behavior in Nanometer Grains

Size effect in bi-crystalline micropillars with a penetrable high angle grain boundary

Effect of low-angle grain boundaries on morphology and variant selection of grain boundary allotriomorphs and Widmanstätten side-plates

Grain size gradient effect on grain boundary mediated deformation of nano-grained metals

Molecular dynamics simulations of polycrystalline titanium mechanical properties: Grain size effect

Atomic scale visualizations of low-angle grain boundary mediated plasticity by coupled dislocation climb and glide in nanoporous gold

B12-P-08In Situ Observation of Dislocation Accumulation and Small Angle Grain Boundary Formation

Role of intersecting grain boundary on the deformation of twin-twin intersection

Direct observation of the grain boundaries acting as dislocation sources in nanocrystalline platinum

Effect of Grain Size on the Local Deformation Behavior Associated with the Discontinuous Yielding in a High Mn Austenitic Steel

Influence of grain boundary activites on elastic and plastic deformation of nanocrystalline Cu as studied by phase filed and atomistic simulaiton