Abstract:This article describes a much simplified, Digital and analog mixed architecture that support general S-band transponder operation. The mass is reduced to under 1.4kg (including TCXO), and the dimension is about 170 *70*100mm. The power consumption is less than 11W measured in the side of 28V input with 1W SSPA transmitter output. The mass cut down is benefit mainly from the progress of digital design techniques and the improvement of the FPGA technologies. The designer implements the IF command and tracking demodulation by a 3 million system gates FPGA. Furthermore, the device is employed with tri-mode-redundancy. The algorithm of the main carrier tracking is based on phase lock loop, the command demodulation is based on Costas loop for sub carrier tracking and DTTL loop for bit synchronization. The carrier acquisition threshold is under -128 dBm with PM/BPSK demodulation losses < 1dB. The dynamic range is from -128 dBm to -55 dBm. The second technique that decreases the complexity is the structure of RF front-side. We use a small size saturated amplifier replacing the AGC amplifier, the saturation amplifier depresses the mostly of the signal dynamic and DSP deal with the dynamic left. We select a low power A/D converter with working frequency under 3Msps in under-sampling mode; however, the IF frequency is about 9.3MHz that can diminish the order of RF front-side down converter and the difficulties of analog band pass filter design. For the standard of the USB transmitter is only support modulation type: BPSK/PM, so we build a RF-IF close loop transmitter architecture that eliminate the components used in up converter architecture, the saved mixers and band pass filters extremely reduce the amount and the volume of PCB. Moreover, we creatively put the coherent forwarding signal generator and the Frequency-Phase Detector together in FPGA. The digital phase noise or jitter is wonderfully filtered by a well-designed analog low pass loop filter. To conclude, there is not any DAC or RF-filter in transponder's transmitter loop. The other advantage is that we can adjust the modulation index easily by digital parameter. The transponder developed by NSSC is under flight verification.

Programmable metasurface‐based RF chain‐free 8PSK wireless transmitter

An Ultra Broadband Passive Vector Modulator Phase Shifter

Controlling spectral energies of all harmonics in programmable way using time-domain digital coding metasurface

Wireless Communications with Programmable Metasurface: New Paradigms, Opportunities, and Challenges on Transceiver Design

An 11 pJ/Bit Multichannel OOK/FSK/QPSK Transmitter With Multi-Phase Injection-Locking and Frequency Multiplication Techniques

Real-time Intra-symbol Two-stage Bit-class Distribution Matcher-based PS-64QAM DMT Transceiver for W-band Wireless Transmission

A 16.3 Pj/pulse Low-Complexity and Energy-Efficient Transmitter with Adjustable Pulse Parameters

A 20Mbps 5.8mw QPSK transmitter based on injection locking and Class-E PA for wireless biomedical applications

Programmable metasurface based phase-modulating reflector for 2.4GHz wireless communications

Toward Sub‐Terahertz: Space‐Time Coding Metasurface Transmitter for Wideband Wireless Communications

A novel programmable ultra-wideband transmitter

A 1.14mW 750kb/s FM-UWB transmitter with 8-FSK subcarrier modulation

Wireless Channel Design and Optimization Method for 1-Bit Programmable Metasurface

An integrated 60GHz 5Gb/s QPSK transmitter with on-chip T/R switch and fully-differential PLL frequency synthesizer in 65nm CMOS

Programmable metasurface for front-back scattering communication

A creative architecture for mass-sensitive transponder

Spatial‐Division‐Assisted Multi‐Level Amplitude‐Programmable Metasurface for Dual‐Band Direct Wireless Communication

A 400 MHz Wireless Neural Signal Processing IC With 625 $\times$ On-Chip Data Reduction and Reconfigurable BFSK/QPSK Transmitter Based on Sequential Injection Locking

A Low-Power FSK/Spatial Modulation Transmitter for Mm-Wave Wireless Links

A Low-Power BFSK Transmitter Architecture for Biomedical Applications